Separate names with a comma.
I am clearly a little bias but I prefer the early a shape to later darts. The roof line to trunk is more appealing to me.
Mine is for sale. [FOR SALE] - 1965 Dodge Dart GT 273
I am curious about '65 GT rear ends. I have seen pictures of others posted for sale etc. but mine seems to be different from the ones I have seen....
Well if my 65 doesn’t sell then I think I will be pulling the motor. The 273 that is in there probably has never been pulled and could use a...
There is someone on eBay asking over 20k for a 65 270 dart gt post car (slant six). Nothing special about it. I straight told them they were nuts.
Well I am interested. I have the original one which I have accidently set my elbow down a few time leading to some cracking. I guess I screwed...
No heater?
Sorry to take this thread in a slightly different direction away from the decal but.... If there was no special distributor curve until ‘66 my...
Whoops my bad.
Nope. It is a very late 65 2 barrel originally with a D4B and an Edelbrock. All the lockdown linkage behind from the bell crank arm back is factory.
I thought they still received the weird timing curve like CAP cars though?
Here are the pictures[ATTACH][ATTACH]
The red is not part or the window sticker. I ended up framing it to preserve it and color matched the mat to the metallic red on the car.[ATTACH]
I don’t think cap was widely used and mandated but my car was sold new in San Francisco. (I have the window sticker to confirm.) I believe all...
Again, I can only give info on how they did the 2 barrel..... But the breather hose on mine is a little longer and would attach to the fitting...
I can’t comment on wether the chrome one had a sticker or not but the 2 barrel one only has a air filter info sticker about service. Also for my...
I guess I will just solder a Little Y in then.
Located the power source. Any ideas on connectors to avoid cutting up wires? Factory connector seems a little stubborn to come off
Just a young mechanical engineer trying to a little extra. Makes my life easier to leave it out though. Messing with electrical stuff makes me...
Are you voting for the relay method and power of the alternator then or just clarifying? Curious about different opinions.
IDK? Edelbrock says to not power it from the coil circuit because it drops to 6V after start. So that would have given me the signal and I was...
Thank you for all the replies. I had initially and foolishly put the relay inline before the coil as the trigger. Maybe I read the pins wrong but...
Also were would you pick up ground? Edelbrock sends such a short ground wire it makes me think the have people attach it to a carb stud. Seems a...
Just to verify... The ballast is the white thing on the fire wall with the two connection points near the distributor/factory coil location. Pain...
Following Up with an alternative kick down linkage solution: I was trying to mock up a bracket as dplasmeier suggested but I am ending up going a...
I know there are some more general discussions on the form with electric choke questions and answers. I am looking for more specific solutions and...
I haven't seen this on my car with CAP. Built in LA and sold in San Francisco. (Built Last week of production for '65). I am pretty sure that it...
Hmm. Do you think instead of messing with the bell crank I could fabricate a rod with two bends / s curve to make up the height difference of d4b...
Like these? Set of OEM 1964 - 1965 Mopar 273 CU V8 Cylinder Heads 2465315 for sale online | eBayI am not sure what you mean by intake surface?...
I am tempted. I have considered pulling the heads and doing a port/polish job and some decking. Once I start taking away material though is when...
