Separate names with a comma.
Will do- thanks!
I have 20 pieces of chrome from a 1969 A108 Van. Some are in good shape, some ok. This is not the complete set of chrome but it does include the...
Tranny
want to come over and help?!!
I think this is becoming a weekend project, not something I do on Monday night when I have work tomorrow :) Also, I stupidly pulled the tranny...
what rebuild kit are you using?
Just to confirm, you talking about the end play between the drive shaft and the fix part in this image? I measured again after tapping with the...
Measured about 20 - 30 thousandths... very roughly with a caliper (0.5 - 0.75 mm).
very nice looking! What kit did you use and did it have the gasket for the tail? I found a urethane bushing from springsandthings.com for $9
Thanks! Just found Tom Hand's book.
Here are the markings on the tranny. On the outside bell housing it reads 432-3 Inside on the plate around the input shaft it reads 3416963 L-4...
Rebuilding now is definitely what I was leaning towards!So then back to my questions- do I need any special tools or literature besides the FSM?...
While my 1969 A108 van is being repainted and I'm waiting on engine parts, I have the stock 727 tranny sitting in my garage. It was parked for 14...
Thanks Bob- I'm looking at the EZ 21 circuit kit versus the Ron Francis kit. The latter is $300 more and I can't figure out if it's worth it...
Just curious if you thought about adding relays for the lights to provide more steady current compared to the stock switches using the EZ kit?
This is great information. Thanks! I will add the transmission to the list of upgrades I might do after I get my engine installed with the stock...
It's a 1969 A108 with the heavy duty axles. The van is actually at the paint shop so I don't know the rear differential ratio. These older vans...
Do you replace the standard dash gear select? I've seen a part from Compushift- is that what you recommend?
Are those electronically controlled? If I were to do that eventually, how do I pick my cam now to give me the best low end torque and low...
I'm building a 390 (4" stoker kit) from my 318 LA engine to power my A108 van (adding aluminum heads and probably EFI). The purpose of this van...
I'm hopefully going to decide on the engine swap in a few days then I'll get to work on the transmissions. I did my first couple engine rebuilds...
I'll still think about it! It would be nice if one of those old tranny guys was nearby to lend a hand.
This is why I might just take the two 727 transmissions to a local shop and pay $1,000. More fun to work on the engine IMO. But at least I know...
Interesting perspective :) I rarely keep a car more than 3 years but it might take me three years to get this van running again!I'm definitely...
Exactly why I'm still considering the 400 stroker (maybe to a 499) with Stealth or Edelbrock RPM heads! I might pop wheelies! But the fit.... The...
I was planning to add a stroker setup, new heads, manifold, etc. to either the 318 or the 400. The main challenges with the 400 are a) fitting it...
All of this still depends on whether I try to squeeze the 400 B into my A108 van or stick with the 318 (or buy a crate 360/408 magnum stroker....)...
Thanks.... I think! I'll read through the FSM and decide if I'm up for the challenge. It's going to be a long winter.....
That sounds a lot better than the $1250 a transmission shop quoted me for doing the work. For someone that's never worked on a transmission but...
I think I got it! I'm assuming I'll need a rebuild kit for the '76. Are there any gaskets/kits for the tail that I need to find for the '69? In...
