Separate names with a comma.
Twice now I have had the distributor connector cause this exact problem.
Heating and cooling was causing the plug to loose the connection.
You will probably need to grind off one of the bosses on the drivers side of the block, as it interferes with some headers.
Test fit after the...
I didn’t suggest the method I did to argue about it.
Just to get a frozen bolt out without it turning into a fiasco for the guy.
Ok fine. you win.
I have done something similar before to the manager of the shop.
I hid on the stepside of his truck and slapped the bed side as he started off...
Too many people can’t even get the bolts back in without the oil pan down, let alone align the balancer hub in the seal.
Sure you and I can, but…...
The oil pan and possibly the gasket, the pump and timing cover, realigning the timing cover and sealing it again.
Not without every...
I use the satin high temp from Autozone and like it.
Being the high temp it’s tough and has the finished texture and sheen that doesn’t look out...
I have gotten 3 out of 4 frozen water pump bolts this way.
The one it didn’t work on sheared the bolt shank and left a couple of inches still in...
Ok stick with me here.:D
Just in front of the block (where the threads in the block are) you can drill a small hole through the aluminum timing...
I think you mentioned early on that was the answer you were expecting.
Sometimes I feel like billing people for the time I wasted ordering and...
Trial beast huh? :D
In my own opinion you should stick to basics and pass on the 340.
One big reason is that you have no idea what the condition of this used motor...
Everyone should watch this.
PFI Speed, a mostly ricer race YouTube channel was fined $18,000.00 dollars for selling engine control modules for...
Everything about this post screams a lack of low speed air flow.
Curious to see the fan and shroud as well, as these are the two main factors...
Damn, I didn’t charge the wife near enough.:D
Six sided maybe?:D
If you are only getting half throttle there is another issue other than just routing.
Like where it attaches to the carb linkage.
I went through this exact thing with Auto Zone for longer studs to go on my rear disc conversion.
They are a Dorman part number and they told me...
How low does your idle go when you brake hard?
Some idle way down on hard braking.
This could cause the pressure to be low enough to trigger the...
Never seen one, but there would only be one reason I wouldn’t use a relay.
It unnecessarily complicates the ignition circuit.
(Says the guy with...
5.9 Magnum dressed as an LA, EQ heads, 214-224 duration with .512 lift hydraulic roller cam.
Hughes springs retainers and locks, Edelbrock dual...
It was right around 80 degrees.I thought of you right when he pulled in.
Have to know ???
She said she’ll be one. :D
I guess that implies more than one, right? LOL
LOL, yes it is the Oregon cam.
I told them I wanted a hint of cam sound, but torque was the priority.
It spins to 7k no problem.
Coupled with the...
Pets have better grave sites than that.
Just a basic no bla bla bla, no music drive in my daily driver Dart.
About anything will fit if you are able to make it.
I have BMW 325i seats in my Dart.
The 325i has a totally flat floor, and the Dart sooo...
Probably not. :D
It was probably one of the 4 cylinders.
Hughes told me, but it’s been years.