Separate names with a comma.
Anyone have a OEM AC dryer bracket and possibly the hardware they would part with for my daughters Duster?Thanks,
Detroit Muscle Technologies are the correct gauge steel and the seal is made of the original material. Work and seal perfectly.
Looking for a nice discharge line for factory AC. This is the line that comes out the front of the compressor and wraps around the battery to...
I have one Rob if all else fails above. It is on the stud so you may need some heat to get it off.
Just joking around @moparmat2000! @Gina Grahame has a similar car to my wife's convertible so we have been talking early Darts on several...
Mmmm... I think I need to change my profile photo to a young pretty girl the next time I need a part @Gina Grahame! I have never had 3 [EDIT...
Boy that is a pricey experiment :). You sure that works and will just any old arm off some modern pump work?
Can you point me to one?
A V8 Carter? I just think that old pump looks cool and you can get rebuild kits.
Anyone have one they will part with? Likely should have M2996S stamped on it.Jim
Great. PM me the details!
Anyone have one of those stubby little things they would sell?Thanks,
Anyone have a couple of the special cone nuts for the manifold front/back they would part with for my wife's Dart?Thanks,
Anyone have a spare front seal retainer channel they would be willing to part with? I "fixed" my rusty one but my fix has caused some issues with...
Sorry no this is for the Daughters 318 Duster, and same problem the end snapped off. Bent around a bit too much.
This is a '73 904 and I need a dipstick for it...Jim
That is one of the claims it makes, bonding NiChrome. We use it for bond wires on RF circuits all the time.
yup have already deduced all that from the original! Have you ever thought of using silver conductive epoxy to connect the nichrome?
Thanks that will work too. My problem is the nichrome wire on the gauge bimetaliic strip has lost in insulation so it shorts out so I need a new...
Looking for a gas gauge for my Dart. My face plate is nice so a faded one is fine, I need to pull it apart to install the electronic regulator...
Yea mine is perfectly straight there is no up sweep on the front edge either.
Everything about /6 oil pans but were afraid to ask.Oil Pan Changes For A Body Slants - Slant Six Forumif it has a stamped number it won't...
@moparraceman and luck? Thanks.
I'm talking about the interior door panel for a 270 trim.
I am sure '63/'64 are the same and I would bet '65/'66 are the same. Does anyone have the chrome trim that runs the length of the front door...
I found one an hour from my house. Thanks.
Hard to tell now..... :)...... I think so just the handle is mounted the other way around.