Separate names with a comma.
I dug up a points distributor and coil to give it another go. I really didn't think it would be the coil because I checked the ohms on the primary...
It is one of those HEI "Ready to run" getups, which has run great for about 5 years, but I think you are on to what it is. I have a points Dist I...
Compression check was normal (whew).
Yes distributor moving was first thought as well. Del, I actually did exactly what you said posted above to check for timing when I first...
Hi folks I am getting a puff of smoke out of the carb when trying to start car. Here's a short video of what is happening. [MEDIA]The Long...
I could be wrong but that brown goop looks like the stop leak stuff.
Subscribed.And good grief next time I am up your way I am bringing the beer.
Could the new trans "kickdown", linkage not be adjusted?
Do you really live in Baja? I live right across the border if you want to hook up my oil pressure tester.
Personally, I would want to know what number was associated with "this graduation" and "that graduation".
I'm not an oil expert but wouldn't 45 points of viscosity index improvers (VI) lead to a shorter service life?
My brother in law worked in the automotive section of a Wal Mart for 8 months. He said anything over 10w-30 can cause oil starvation to the...
Glad to see it is getting close. I have been in the same boat trying to get it perfect.
If you get pulled over keep your hands away from the banana.
Hughes makes a shim spacer kit for those rockers if you want to tighten them up.
Is this the bend you are looking for?
What throttle/kickdown linkage is that? Beautiful ride!
How dumb of you. I never did that.......Twice.I got pretty lucky and was able to cut a slot with a dremel cutting wheel and back them out with...
Which pcv did you get?
I am probably the least qualified here to diagnose your problem but could it be the coil going bad?
I just bump the starter relay with a wrench and adjust the ones with closed valves and write it down. A few minutes later and done.
Have you put in yet? I had one similar to that on my 66 and it was too tall
The best solution would be to ship it me in san Diego. I'll drive it all Winter for you and you can have it back in the Spring.
Leak Down Procedure (Pic Heavy)I made this s few years ago. Might help.
Have you put a vac gauge on it?
Personally, I would compare some options between a 273 rebuild and what you can find in a complete 318/360 "cruising" motor and putting the 273...
Yep. Just checked two different boxes and one was Chicom other was Mexico.
By my calculations your initial timing is too high. It should be 27.86*.You are welcome.
When I was running the 273:
[ATTACH]The day after installing the 318:[ATTACH]If I went 340:[ATTACH]and 360:[ATTACH]Indisputable...