Bitter and Cranky?
Probably a little bit although not deliberately------------ after a 1/2 Dozen Cancer Surgeries including
a 12 Hour Kidney Cancer Surgery at USC where I died 3 times during
the operation. Not to mention the realization that I am out of
time to Fulfill my Dreams.
These Pistons will give you 9 to 9.5 compression ratio with stock Iron heads.
They are an accepted part # for NHRA Stock Eliminator for 72 or 73 340 Stockers
They are stock balance and should not require rebalancing your engine.
They are really very low use and Nice.
They would be great for a...
These R3 Blocks are so rare and expensive that not one out of 1,000 guys on this
forum would ever acquire one or have any use for this information and all it would do
is waste space on the forum and your time.
But I appreciate your feedback/Opinion and I have withdrawn my post and offer on this...
Our Converter Shock Stall to 5900 with a few feet of leaving the line given no
tire spin. Shifting @ 7,200 it drops to the same 5,900 on the shifts. Our changes
in ratio thou between gears are more extreme than most people.
We run some ATI convertorsalso but they are custom done for us to...
There are over 100 different combos of straight cut different ratios in the straight
cut Pro Trans gears we utilize. 2.75 / 2.54/1.00 as I recall in factory 904 low helical gears. 2.45/1.45/1.00
in standard plantaries.
The straight cuts take less HP to turn but they are a $1,500. set last time I...
If the piston skirts are very worn = It is likely that the
ring lands on the piston are also work which will destroy the
ring seal! New cast pistons are not expensive.
Also if the pistons are are more than 50 down in the hole (I have
seen them 100 plus in late engines) it will really hurt...
I have a nice 6319S that has been in the shop for 40 years.
Moves freely and complete. Shafts are nice and tight with no excess play.
$225.00 plus $24. for shipping plus insurance.
I have several 918 intakes
I will check the dates
$150.00 plus shipping
This was on my Son's original 340 Duster4 Speed for Six Months before
we found the right number AVS for it,
It is nice / crisp and lean for a street car that is running through the muffler.
Plus $24.00 shipping/Insured
Here is a set of original when Schumacher\produced Lazer Cut
New in box Motor Mounts.
The company that bought them out is having issues getting the reproduced.
The owner is my friend and I have been waiting for a set for many months!
We just found these today in the shop!!
These are the original...
Radiator would be too expensive to ship.
I will have my son go to the shop and take pictures of the repaired 68/69 one.
It looks fine on outside but repaired on mating surface.
It did not leak on the race car but you be the judge?