Search results

  1. K

    Intellitronix A-body Dash Install Thread

    I had to ground the dash panel because you have to remove the metal so that my wipers worked. You may have a ground issue
  2. K

    Intellitronix Fuel Gauge Reverse

    Fwiw, I did not follow the instructions to the letter. I did use the existing wire in my dash wiring. It was working fine to begin with. I have a tanksinc fuel injection tank and their sender. I did not want to run a new wire under the carpet and seats. To me when it gets to 60 I am on the...
  3. K

    Intellitronix Fuel Gauge Reverse

    Yes . Same one. I have an install thread here somewhere but I did not address the fuel gauge in it
  4. K

    Intellitronix Fuel Gauge Reverse

    Mine also counts from 0 to about 70 and I have to put in 16 gallons of gas. I meant to check what the capacity of my tank was but I forgot. Time to check that now. I carry extra gas in the trunk, Trufuel from home depot as an emergency. It sits in the spare tire well.
  5. K

    Dentist

    Firstly, Medicare does not pay for dental services unless you have a Medicare advantage plan. If you have one of them, then you have an insurance company that administers it. A dentist may or may not be in network for that plan. If, for example, Metlife is the administrator of the Medicare...
  6. K

    Dentist

    There are pre-requisites that are required that take up at least 3 years of study, undergraduate. You also have to gain enough knowledge to perform well enough on the Dental School Aptitude Test. This is what is needed to get into dental school. Dental school is not a technical school. they...
  7. K

    Dentist

    That is what it takes to be a dentist. A requirement. You can do a residency after you become a dentist to learn more skills or you can go on to specialize in limited fields like Oral surgery, Orthodontics, etc.
  8. K

    Dentist

    I love my hygienists. They do great work for our patients. They assist me in so many ways that I cannot thank them enough. However, they do not know anything about what the costs are of running a practice. For example, let's say they earn $45 per hour and see one patient per hour. The...
  9. K

    Dentist

    I have been a Cerec mentor for 12 years. It is great. So much misinformation out there for us to battle.
  10. K

    Dentist

    I don’t even know where to start. As a practicing dentist for 35 years, I have seen many people who have similar experiences as you have voiced. First thing that must be addressed is that the insurance company is not the dentist. If the treatment you want and need is not covered, that is your...
  11. K

    Who has a back up generator (permanent install)

    It took me 10 months to get mine and it was installed in February of this year.
  12. K

    Who has a back up generator (permanent install)

    I have a Generac, natural gas whole house generator 22-24k . It tests itself every other week. While I have not used it yet, it is quiet and ready to go. With natural gas, we should be good.
  13. K

    USPS Flat Rate Box Prices Increase?

    Just for comparison, try the pirateship.com estimator and see what they would cost. They ship usps and ups but rates are much better.
  14. K

    USPS Flat Rate Box Prices Increase?

    If you have not tried Pirate ship for shipping, check them out. I shipped a golf club for $16 across country. USPS wanted $15 plus $21 oversize fee. Free USPS and UPS shipping software | Pirate Ship I cannot believe how they do it. Their insurance is a bit different but it works well.
  15. K

    Thinking about a Gear Vendors OD. Can Anybody Give Some Guidance?

    https://www.forabodiesonly.com/mopar/threads/727-tailshaft-removal.489207/post-1973421001 This was all I needed to do on my 73 scamp. Air hammer worked great. I had a little trouble because my tailshaft retaining clip was on the side of the transmission, but that was all. Still doable. See...
  16. K

    Thinking about a Gear Vendors OD. Can Anybody Give Some Guidance?

    I love my GVOD. #.91 gears behind a 727. My 70 mph went from 3500 or so to 2700 or so. Much better all around.
  17. K

    Parking Pall Blues

    Are you referring to the plug or the sprag? Could you circle the area?
  18. K

    Parking Pall Blues

    I did just buy one on eBay for that reason. I will compare the 2. I would not know how the check what is the correct orientation or which way to bend it .
  19. K

    Parking Pall Blues

    My parking pall control rod snap ring has slipped again. I cannot find a replacement part anywhere. Does anyone have a source for it. If not, Any ideas on how to secure it so that it does not rotate and allow the control rod to fall off the plug and not activate the park. pic 3 is mine. Pic...
  20. K

    Forum Software Upgraded

    How do you hide or block a thread that you do not want to see. Some are offensive. Some are just banter that you don't want to see.
  21. K

    Singers

    Hello,,,,Willie Nelson
  22. K

    440 Help Needed

    For me that would be very predictable...:rofl::rofl::rofl:. Don't mind me. I am just a dentist.
  23. K

    Prayers Needed

    Prayers for you now.
  24. K

    National Overdose Awareness Day.

    I agree that nothing should get in between the dr/patient relationship. Especially pharmacies or government. Yet, we have long needed a way to curb multiple prescriptions for the same disease coming from different providers. And many paid for by government programs at no cost to the patient who...
  25. K

    National Overdose Awareness Day.

    Dentist. For 34 years already. I do many involved procedures. Many patients every day.
  26. K

    National Overdose Awareness Day.

    I see mega prescriptions for opioids all the time. If I ever have to prescribe any narcotic, I run a prescription history on my patients. Some just got 90 hydros just last week and want Percocet "because nothing else works". They get no narcotics from me. When I do write them it is for...
  27. K

    Alignment finally done, but ?

    It was Perfection Tire in Post Falls. I did ask them many questions before bringing it in.
  28. K

    Alignment finally done, but ?

    You inspired me to take it for a trial. I went down Riverview, Mountain road with many tight turns. The steering is tight and true. It returns back without a problem. It did not seem to oversteer or understeer but followed where I put it. Then I did full acceleration on the freeway onramp...
  29. K

    Alignment finally done, but ?

    They did take right at an hour to do it. 2 guys. One looked to be learning. I previously asked if they could do it and they assured me they could. When the guy checked me out he said they allow for 2 hours with classic cars. Cost was $119.00 I thought that was fair for what they did.
  30. K

    Alignment finally done, but ?

    It says .30 degrees. With a 25 inch tire that calculates to .130 inches, combined. I will measure in inches later this weekend to double check.
Top