Separate names with a comma.
Sport340... Is your speedo reading correct. the rear gear may have been changed or the trans but now it doesnt have the right speedo drive gear....
seconds are good they're all over the min. open #3 top to at least .026 min like the rest.
Imo 3 is still tight. Second should be 4.00x.004= .016 min. The rest look ok. Good luck.
The KB's move the second ring a bit lower. I'd gap them all the same @ .026" +[ATTACH]
I used the chart in post 4. I kinda remember mine were .026" for a .030" over 340 with KB pistons.
The service manual is speced for cast. The hypereutectic need more ring gap. The piston maker should tell you what gap they want. Go by that.
Take the window out. You'll be shocked. I removed the lead and used short strand fiberglass after the metal repairs were finished. Mine looked...
here's a story on the history of them...EH!
The drone (resonant frequency) is gone at all rpm but when I stand on it the exhaust tone is all there. No restriction either.
Its welded to the tail pipes after the mufflers both sides. There's a welded in cap on the adjustable end. If you look at the Pypes lineup of...
Yes the short pipe thats capped is adjustable about 6 inches for frequency. I found that it didnt make a lot of difference in tone on my...
I have to confess. I found a place to put it and installed it but a local muffler shop sells the stainless kit with the band clamps. They say they...
eliminated drone completely.[ATTACH][ATTACH][ATTACH]
just make sure the hard line does an upward 180 above the filler before it goes down thru the floor or you'll be spilling fuel when the tank is full.
is Mark Warman on this site? shoot him an email.
my 67 is open to atmosphere outside the frame rail. I wouldn't want the frame to be full of fuel fumes. Dont connect it to the tank or it will...
Amsoil ZRod 10w30 here.. even with my roller cam and roller rockers. Just cause I love my engine. Ps. Not a slant.
code 531 Left Headrest $20.95
532 Right Headrest $20.95
bucket seats only
do the holes line up with the manifold?
I didnt think your ratings were the same as north america. Wasnt sure..
a low compression 400 with a 268/272 cam and 4;10 gears certainly doesnt need 95 fuel. whats your regular's octane #? changing to 3.23 or 3.55...
until you look out the window and see a Chevy in your driveway!
$ 2819 says wide oval tires are standard but they hosed him for $31.60 for D70/14 WSW... guess white walls cost $31.60 extra. :lol:
Herb's Parts: FLIP FUEL CAP SECURITY SCREWS & TOOL 67-69 BARRACUDA, 68-70 CHARGER, Fuel Caps, FLIPTOPSET
I owned a '73 Duster that I bought new with that colour I think. I dont remember the code but it was called Autumn Bronze Metallic.[ATTACH]
thanks.. my 5 speed is .68. I just wanted a comparison. Ive thought of one if I do something with a 727.
whats the reduction ratio??
I use it on the master cyl and the rear diff also. POR15 manifold cast iron.
POR 15 manifold paint brush on. cast iron colour.