Separate names with a comma.
This And add some springs..
You have the "car" engine mounts, pan and p/u tube to convert this? Engine mounts in pic looks like it was in a truck.
Here's some more of it, 14 years ago, looks a bunch cleaner. AND just for you @MOPAROFFICIAL , includes the 4.00 inch adaptor.[ATTACH]
Yes this is a GM, but the concept can apply to any engine. Saves getting dirt/ filings on pistons and the crank. Not all the pieces are pictured...
End view of the OZ head.
Personally, I think your safe. If this works at .200 off set and .300 off set, .040 is good to go.
Crank Shops for Offset Crank Grinding? | For A...
Fred from FAK machine in Edmonton had also discovered the use of chink aluminum radiators with an internal oil cooler, was causing thrust failures...
THIS. 512 B Underway
ALL of your exhaust ports are "dry", if coolant was being consumed, one or more of those exh. ports should be wet/ discolored/ different. keep...
Summertime in Saskatchewan.
Rusty, that gauge is likely as old as me and you. It's seen a lot of holes.
I've been well aware of the need to use a torque plate on a 440, that's why I have one. So being that it was 440 day again, I photo'd finished...
72 + truck rear sump, sadly, shipping would be too much from here.
Google streets, in the early days.
I lied. it's only 36 below here today. This is from a V8, yours looks like a /6, attachement point looks different, but its 4 and 1/2 inchs long....
Must be just your luck, most ,not all ,I've worked on were preped.
Your 440, does it have a cast crank? If so,You'll also be external balanced. Forged crank, likely internal balance, usually is prepared for an...
It's gona be 40 below here in a day or two here, but I'll be working on my d100 this week end and could get some photos before I shrivel up.
426ohyeah aka meatball, in his younger days, just finished cooking something up in his moms kitchen.
Do not despair Ford lovers, Mopar stuff does fit your ford. Heads been v-j'ed to death, in goes the Mopar P4876580 valve, at 2.150, 3/8, 5.4065...
You'll also need the the floor "hump" under the console too.
I'll PM you.
Not Mopar, but still applies. It would be nice if the Dudes that cobble up these stroker kits could put that final bit of thought into what their...
What, no studded tires..
AND, they're about a 100 thou. too short.
What do you want for a t-set? Cloyes or JP?
X heads got the 3/8 valve? Speedmaster got the 11/32
@oldkimmer , you got anything?
Here's the aftermarket "3V" version for the 351C. [ATTACH] [ATTACH]
One more area to be inspected would be, did the guy use a rubber? hose pieces on the con rod bolds through the dis/assembly procedure. The # of...
OK, I'll add this, whadaya think, this ,plus this? In my "log hauler".