Separate names with a comma.
Third gen Race Block. T/A, X, then R3. There are different R3's . Lifter angle and height, Deck height, and Engine mount tab's. Shaved head...
Make sure its the parts you are handling. She may be looking for more then cash. Let us know her figure and what her hair color is. Leave...
It doesn't matter if its in Comp. Or Exhaust stroke. The slot for the distributor in the gear is always inline to the front intake bolt. You can...
Small Block, Put the engine on top dead center . Timing mark on zero , Firing or Exhaust stroke don't matter which. Install the drive gear with...
I've see that twice both times it was the distributor cap. One was a new mopar mechanical advance with a tach drive. Both times the cap mounting...
The caliper looks mounted to the bracket wrong, It should slip under at the top and set in at the bottom.
The nuts face out, You always hit the bolts toward the shock when removing. It is easier to hold the bolt in place and then torque the nut during...
I would just drill holes in the pins. Then install a flat washer and cotter pins. You can add washers to tighten them up and keep the hinge from...
I fitted quite a few up from b-bodies when installing the engine and trans in A-bodies. If I remember correctly the lever on the trans was longer...
70 and earlier 3 piece linkage is the same in A, B, C, E, bodies if it 3 piece. Most later models are one piece accept for A-bodies due to...
1969 sport Satellite and GTX [ATTACH]
Your running green antifreeze which doesn't like something aluminum in your system after sitting . Switch to the orange antifreeze. Small...
Could have been carried into the garage with the tire. Or the Neighbor blew it in while cutting his grass.But I would suspect your wife making...
Here is what I found with my car that had the same problem exactly. My radiator had swelled tubes from the cooling system being over pressured....
Yes, Leave it on for the street. and take one link out on one side for the track. That is what I did with SS springs.These cars have a bad...
What you need to have is 12 volts while cranking and 8 volts when running. 12 volts while running will ruin the coil.When cranking the 2 blue...
There is no right or left they have the same part number on all the sets we installed. Torque wrap is controlled by the caltrac adjustment.
We installed ours so they have adjustable ride height as the front hangers are . They are removable and can also be moved forward or rearward....
You will need to file or grind them flush. Carefully drill and tap them for a 10-32 stud.
They are for early a-bodies 62-66 I used a set on a 65 barracuda they worked good on the 340 installed
Did any of you ever use a Timesert? My son uses these. They are expensive but very efficient. Much better than helicoils in some applications....
You can hear it clear as day not firing on all 8 cylinders. I wouldn't start it up until you check what the problem is . Take the valve covers...
Does not sound good at all. Definitely dead on a cylinder. Make sure your adjusting them at the correct time. Valves are to loud The proper...
first row I don't know what I will bring but I'll come to buy and sell
I'll ask him later today.
That's an easy fix. use it
A very well balanced engine will keep on spinning up. A Engine not well balanced will come apart quickly. 416, Indy 360-1 heads. 686 roller. 2"...
Have it filled in with spray weld and redrilled. My son repairs blocks with this method.
It don't take long I have 5 and my son has more then I do already. I think tools are a sickness.
For how long?
