Search results for query: *

I'm not sure if its still there. I was only there on Saturday.

Someone wrote "sold" with a paint marker on the hood and trunk. Not sure if it can be seen in the pictures

Haha! Sure as hell looks the same. They are cutting the grass around it at the fairgrounds.

Saw this today at a jeep show at Carlisle. Just reminding you that you have to still pick it up. Haha..

He's saying he has one for $75.

Vinyl Top Over Drip Rail? Here is the thread that I read about the green tint. I'm not sure of the actual dimensions.

I thought the trim for vinyl had a green color/tint on the inside?

No good. It was for the car I have to put back together. I didn't see any extras. Hope ya find it at Carlisle. Carl

I may have some I can bring if you don't come across them. I'll have to double check to make sure. I can't remember how clean they were, but I'll grab some pictures if I find them. Carl

Ok np.

I may be bringing both 15x7 and 15x8. I'll have to check today to see what I actually have. All are small bolt pattern.

Yeah man. Good luck, hope they help

Not sure if this helps, but here are pictures off a 71 demon door. Everything is laying exactly how it came out of the drivers door. Couple of photos of the brackets inside of the door as well. Carl

You can also use this instead of the bellhouse. Just stay clear of the flywheel. You'll get an ouchy!!! Just saying. SMALL BLOCK Chyrsler starter plate | eBay

Pm sent

These are the clips your looking for. I couldn't find them specifically for the seat pivot pin yet, so I can't say that they will be the correct diameter. It was a while ago when I did mine. When I put my seat backs back on I just put a plastic washer behind the arm so it didn't dig into the...

Pm sent

14x10 with 3.75" back space. One more inch of backspace would have cleared all the way around and tucked in there nicely.

A friend just gave me these. I have to lift the rear up a bit to make them work. Reminds me of the afx slot cars. Kelly super charger M50-14

Your near @Oldmanmopar territory. Look him up as he's had a bunch of duster parts. Carl

This was back in September of 2022 when I called, but they said 3-4 weeks.

I didn't actually look to see if the A100 material was there, I just wanted to pass on their information for you to try. I recently had my seats done and the guy said he gets all of his material from this place. Not just mopars either. He claims they have the largest selection of materials...

Sms auto fabrics in Oregon.

Can I ask where you got the dash pad from. I will be looking for a blue one in the near future. Carl

Pm sent

@69GT

Another picture

All of the lines go directly to the tank from the stand pipe except for the one, that went to the front of the car to the vapor return line. I think that's where the shorter rubber hose went? Its been awhile, I'd have to take a look again. You also will need the correct tank for that year that...

I used the AMD qtrs and had the same issue. The angle was off a little too but not enough to be a problem with the fill tube at the floor or tank. It was decided to body work the cap to match the body. It would have been alot more work to get the qtr to match the cap. It wasn't alot but enough...

Any further progress on the new stripes or black paint?