Separate names with a comma.
Is that gasket reusable then? Probably depends. I have felpro 1008 for my build. sorry for the hijack Doc.
And then I suppose you can leave the head gasket out and just add the compressed thickness of the gasket to the measurement.
SM did have a problem with the rocker shaft pedestals. B3 Racing was refusing to address the issue. Not sure where the stance is now.
You seem to have the money to play. Just call Mike at B3 racing. Have a nice conversation with the guy and put in your order.
No, been a while. I recall it being reasonable. 200???
All of the kits are custom. Mike sends you the info he needs to get the measurements he needs to correct your geometry.
You already had to by different pushrods to make this work. Right? B3 racing is the ticket. I really don't see a small amount of relieving being a...
Bottom end usually dull knocky noise. Top end ticky. Plus the timing of the noise is diagnostic too. Those bearings look good as far as I can tell.
Good to know. Thanks for doing the ground work. The picture looks like all of the speedpro rockers and when I was shopping I did run into the...
Sale price is more than regular price LOL. PLUS... I believe they are NOT Harland sharps. Not that I think Harland sharps are better than speed...
I cant find them. Can you give us a link? I know they used to offer that deal. I just cant find it now.
No argument there.
Over rated mostly because people put the flat tappet down for the wrong reasons. No doubt the roller is superior in most cases. I just think...
How about a vote on how roller cams are over rated. I think flat tappets are getting a bad rap due to dirty builds and poor break in procedures.
Last time I looked, aftermarket pistons are hard to come by.
If my notes are correct, this is the part # for the pushrods needed to use 273 rockers with hydraulic lifters. Summit Racing SUM-G6420 Summit...
As soon as you post a question about it. Ha, had to jump on the wagon.
Would it be the end of the world if a person left one off?
Not a very good one. lol
They gave me a discount by going through my business. Not sure what percent. They emailed me a list of the new prices about 2 weeks ago. I guess...
I guess they do sell bare heads. Thats about what I paid for my assembled heads last summer.
And can go to 2.02 valves if the 1.88 are sunk.
Can you buy bare heads from Promaxx? I mean, building them is what they do.
There are so many trade offs with engineering. I find it hard to have a fair comparison but what PBR is doing will be fun.
Probably referring to spring retainer clearance. Only the head itself or shimmng can change rocker arm to valve geometry
Here is the proper link for searchtempest.com
It lost me at the picture
In his thermos which he will clean out and fill with paint.
That stroked magnum is internally balanced. You can use la heads on a magnum. La intake manifolds can be modified for magnum heads. The combos...
skirts
