Separate names with a comma.
Awesome guys. Yes, one of the first things I did when I got this Dart was to install relays on the headlights, I was told (by this forum) that...
Yes I just tried a few things.... Replaced the light - same issue. Then swapped the relays, ... same issue. So relays are good, lights are good....
Driving the 66 Dart again, after putting about 10 miles on it all of last year. Go to turn on the headlights and nothing, but I hit the hi beam...
Sounds like a great fix. What I do is just turn the nozzle sideways and put it in. Then listen carefully as it start to fill.
Any help. I did the scarebird front disc conversion on my 66 dart. rear it still the 9 in drums. I changed out the master cyl with a newer 2...
I want to update and conclude this thread. Few things I wish I had known before I started. Parts list: Motive C7.25BI $80 gears (amazon) Felpro...
This is great info you guys rock. Let me ask , will that carrier and large gear come out easily or do I need to also remove the gas tank? BTW I...
In the manual it says the Drive gear bolts are left hand. But what is the drive gear? That big gear? I was hesitant to remove the whole carrier...
[ATTACH] And there it is, rotated and there is a roll pin, there is no way to pish it out. So what do i do? Drill it out? Then need to find a new...
[ATTACH] Ok emergency. I am now looking to remove the pin that holds the spiders and there is no bolt holding it in? And one end is slotted? Does...
[ATTACH] Here is pic of the shaft. Bearing seems fine. Maybe just thin film on the outer race, [ATTACH]
Ok i was able to leave the brakes connected and on . Once i undid the 4 screws the shaft just slid out. So do i do bearing grease on outside of...
How do you push the axle shaft back into the spider gears?
Another question, how do you go about flushing out the differential with it on the car and jacked up?? I waved a magnet in there and tried to get...
Great info that's so much. I ordered the Motive kit on Amazon for $80. Now in the manual it talks about race and bearings on the axle shafts....
Can you tell me more on how you did it? or where the earlier thread is? Were you able to do it while it was on the car or does it have to come off??
Ok on a whim, jacked it up spun the wheels and I feel it get stuck, wheels are spinning opposite each other, so not sure grip. Pop off the cover...
That’s right it is not sure grip it is the 7 1/4
66 dart, sedan, L6 with the stock suspension and axle and differential. 7.25 Everything been going fine, until yesterday , whenever I turn to the...
Anyone know approximately what the distance from the road to the K member frame should be? Mine seems really low to the ground, and is scraping...
What is the protocol for adjusting the hood? Is it a 2 man job? So I tried on my own, and only one side and made it worse. I can't understand...
where did you order the foam seal?
not used, though some people use it as a washer for the little hex screw that holds it on.
I have the same mirror on my 66 dart sedan. I do not think there is any repairing the looseness. Although I do think you can pop out the ring...
are you talking about the triangle shaped washers? or the 2 round washers?
I just did this to my 66 dart. except I did Scarebird. I did lots of research on finding the 15/16 bore, and this is what I found. Dorman M80266...
Any help? 66 dart swapped to disc in front, new master cylinder. And the original pushrod seems to long, so I bought one of these Adjustable type...
You can find repop version of the pedal on eBay for about $60. but it is just the pedal.
66 dart, recently swapped into disc up front, drum in the back. Foolishly I assumed that the brand new dual well master cylinder would be leak...
Are you saying the spring is not needed? It does feel like when I push brake it takes too far before braking begins. And as I let it up I can...
