Separate names with a comma.
No reason No reason to be sorry. Thats a cool setup you have there! If anything I feel envy!
I will run a torqueflite sometimes. Its fun to drive. Your setup looks rather exotic. Interesting. Fill me in? Thanks!
I will buy that,thanks!
Flywheel bolts are longer. Spacer requires longer bolts.
Are those the flexplate bolts or the flywheel bolts?
Turbo 400?
Mount em tight to each other.
What you all doing for fore and aft support? Those motor plates will flex.
Perhaps his doppelganger!
Here you go. Small block chevy tunnel ram, two adapter plates. Thats about it. This was done quite often in the 70s. Do some measuring and you...
I have a few, 66-67 and one other, motors books and a 69 chrysler factory service book. A number of chiltons and some haynes. Some chiltons and...
Why not weld some nice beads on those undersize counterweights and save most of that mallory money?
I got a couple of clutchflites for my dart. Lakewood scattershields. With all the bolts of course. And behind that, the bulk of a 727 gearbox. And...
I got to disagree here. I remember when every track had a watering hole. Guys could dump their water and refill with cold water. They would run...
This is a big no-no at the strip. Antifreeze is difficult to clean up. Water isn't. Surprised nobody has mentioned this.
Yes, I checked it out and grim reaper is right! Always learning something on this site.
But the bearing does not ride on the input shaft. It rides on the sleeve over the shaft. The sleeve is part of the front bearing retainer and is...
Read this and what came to my mind? Kurt Russel and his little black book in the bar scene of that cool movie Deathproof!
Well now thats not ignorance, thats laziness! (Thats- that's- that is). Single finger pecker here.
Dont forget that we learned how to use paragraphs properly in our compositions. And the importance of punctuation too! (Couldnt help myself.)
Oh,thats a bitch. Thats something that your spending any money on your car! Hope that crap ends now! Good luck to you!
I didnt say I was right, said maybe I was just lucky. I did a little research at ARPs websight faq page and well they say reuse is quite...
Hmmm. I have reused head bolts. ARPs. No problem. Never lost a head gasket. Some retorque head bolts after running a motor a bit. I dont but... ....
Wow, this hurt. $3.30 a gallon in so cal. I try not to look at prices. What can I do? If gas sales dropped I dont think prices would drop. Might...
I dont think its timing. I think its a no spark condition. Timing off it would kick back or back fire. It would show signs of a spark. Spinning...
Hey, keep it down! I wouldnt want my 40 something year old sears timing light to hear that....might not like it. Yeah, back when "digit" was a...
25 or more years ago I wanted to put a bottom outlet on the gas tank of my 64 plymouth. Drilled a hole, screwed in a brass fitting just a thread...
I ran a clutchflite in my 32 bantam altered nostalgia car. Injected hemi on alky, 100" wheelbase. Thats 254 centimeters to everybody else. 30 lb....
How much weight you got on the front axle, if any?
Part 2 of this thread. What can be used to loosen the grey stuff up? You know, spray and wait instead of chisels and crowbars on our prized...
