Separate names with a comma.
IMO, In trying to position an oil pickup with pipe thread, just that needed quarter turn more can stretch the tube at its weakest spot. One might...
Congrats to M & D!Is that a Breakfast Dagwood?:)More of the over easy for me..... [ATTACH]
There's this......... Mopar Tech Pages (mopar1.us) and this..... Tech Index (archive.org)
Are they all made the same? IMO, I can't imagine a particular weight as a gauge to go by. I'm thinking buoyancy needs to overcome a pressure in a...
Heres what I pressed out of my old DS axle. Another member needed the Lefts so they are gone. I never did measure the knurl though. The rears were...
PM'd
I don't think it's for an Abody then again.......... Brewer's Performance - Mopar A833 4-Speed Transmission and Component Specialists...
................ [ATTACH]
Knurl size??????..........Moroso 46150 Press-In Wheel Studs, 7/16-20 x 2-7/8 Inch, .480 In. Dia (speedwaymotors.com)Mr Gasket 4310G...
How hard up are ya'? I have 7 in "distressed" state :eek:........... [ATTACH]
My old truck has never leaked, but it does squeak..................[ATTACH]
FWIW, Some of these may not be real friendly to an Abody with a 2 speed wiper motor. AC can even be an issue. Below is a "shaker " base plate on...
............ Nick's Garage - Air Cleaner Identification (nicksgarage.com)
[ATTACH]Lol, my brother just sent me this picture along with a jab. He's a Chebbie II ('63) fanatic and thought he was being funny. I told him...
We weren't all here 'cause we were all over there!
Lol, I was thinking mud daubers.
IMO, you'll likely pull the rest the threads out of that bolt hole if you don't fix it correctly. I'd also go back through all the hold down...
FWIW........... [ATTACH]
re-pops........... Catalog (laysons.com)
When all else fails, maybe form a stiff wire such as a coat hanger to mimic the center line of the hose form you want/need. Match it up at the...
You're probably good, but you might want to make sure the adjusters turn freely as well.
I'd say reset the linkage again. With the rods off and tabs on, I cycle each shift fork through the gear positions and return to neutral. The...
Did you add lube into the crank hole behind the bushing? FSM say's 1/2 teaspoon I believe. Does it grind when it goes into reverse, as in the...
There are transitions spot welded on (re-pops available) [ATTACH]as well as the inner FWs.... [ATTACH]If the K member is still in, I wouldn't...
IMO, if you're going SB, nix the FWs. With the engine out, I wouldn't expect it too difficult fill in if that's the route you take. Cutting all...
Why take a chance on the steering not cooperating? At least a tow dolly. For longer distance, maybe some tow hubs for the rear?
These 7/16" rear drum studs were as you describe. A little tuff to make out the "L" on this shot but it's there...... [ATTACH][ATTACH]
These are listed here I believe....... NHRARacer.com - NHRA Engine Blueprint SpecificationsThey are in "MS Word" format. A download link is...
This is the plate I use to simulate the disc.......... [ATTACH]I believe one could position flat stock to do the same.
Lol, No whoops here!It's measured to the standard (red) which is .310" (disc thickness), not to the flywheel.[ATTACH]
