The truth US Companies, we make good stuff but we make a hell of a lot of mistakes!!!
January 2 1968 Chrysler started using hurst shifters again. 68 A body hurst shifter handles is an half year only shifter handle.
I ended up using the one that came with it. 1/4 inch spacer and move the holes in.[ATTACH][ATTACH]
I tried using a stock one from early a and 68 and up they both do not work. The easy a fork bracket, the fork is in to far and up
After searching here I think I need to use a stock fork pivot
Got the pressure plate back nothing wrong with it. So I shimmed out the bracket and that work with angle but notice the throw out bearing is not...
Who is running a Quicktime bell on a small block
Question is what fork pivot are you using.
Throw out bearing not center to pressure plate forks
The one on the top is the 5973, hard to see in the picture but is a little shorter. Also angles down
I will take pictures tonight
I have all 3 but stilll does not help on what the shorter on fits. I personally thinks it’s for January of 68 a bodies.
I have only seen the 7036 shape for 69 to 74ish(I know they change it from a slip in to a bolt on) then they change handle to bend up. As far as...
Hurst 4 speed shifter handles 7036 and 5973 fit (bucket or bench)???
Need a little help here.
The 7036 I am more familiar with most 69 to 70...
Well already sent my pressure plate back to Mcleod. see what happens. If no problems this is what I will have to do. thanks
I called McLeod and they said that the had a run of them with the fingers to short. They said to send it back and they will take care of it. Bummer
it could be the B&B pressure plate I guess
The only difference is the dice is 10.95. the flywheel is 10.5
yes I used the A body bracket
McLeod Super StreetPro Clutch Kits 75238
yes all new
McLeod super street pro 10.5-10.95
I have to have something wrong.
One more thing, the more I adjust it the better the pedal come back up.
I put the extra nut on the adjusting rod.
Do I need a heavier duty spring?
Here’s a couple of pictures
I am using stick fork also[ATTACH][ATTACH][ATTACH][ATTACH][ATTACH]
Hope I can say this correctly
I am at the end of the adjustment and throw out bearing is just about hitting and when I press the pedal down, my...
Nobody using this set up?
small block QuickTime bell with TTI Z Bar
Any body have adjustment issues?
I like the CP because of the stops, you don't over throw the shift when hammering on your car. Its saves the forks on the inside of the trans and...
All I have to say try. I have and if you're not ordering 5000 to 10,000 units (pieces) at a time you are a minnow in the ocean. How many pieces in...
I talked to Jamie. They are getting the trannies out. The problem is he is so busy with all his other work that its hard to do both. Not to many...
Separate names with a comma.