Separate names with a comma.
1972 Hamtramck Michigan build location 555993 serial number.
They were intended to go behind the balancer. Never! In the engine.
Do you know if it ran smooth in the van when it was running?
I was kinda thinking the same thing. That is why I asked if the trans that was behind this engine have a weighted convertor?
Was the 727 that was behind this engine, have a weighted convertor?
Were the internal components a match. I mean crank, pistons,rods?
That is the right flex plate for the 904. I wouldn't think it would be in the 904 because you say it does it in neutral. Everything that moves...
Did you use the B&M 10236?
If it cost money there is a reason not to. IMO. But it is yours so have at it.
Why would you want to?
I have this one.[ATTACH]
Your going to have a fit getting that cover off. The TC erodes right there where it meets the block and allows water to leak where that broken...
That is the same pan I have.
Should be the same one I used. I different problems with it ,but not a sealing problem.
RMS in a 68 Barracuda, oil pan problems
Which Milodon pan do you have? What is the part number?
I've never had that much trouble getting a pan to seal there. I use RTV on the pan and the seal. Have you used a different main seal yet? Make...
Are you sure it is not coming from the back of the block up higher? Or the center of the crank register. Have you ran this assembly before or is...
This is the 416 in my 68 Barracuda[ATTACH]
You mean this?
Is it just me or do I need CC on this reply?
I agree with grumpy^^^^^It's the way I've done it since Moby Dick was a minnow.
The Second picture, the one in the block is wrong, it's in backwards! The second thin lip is just a dust/dirt seal. Rule of thumb is the lip faces...
I'll add my 2 cents. Don't over cam it!
Builder may have put one half of the rear main in backwards. Not that hard to do, I've been guilty of that.
Not sure if this procedure will help in your case if there is a piece of foreign material wedged in the valve? If it is due to sludge it might.
No you can pour the kerosene in the oil fill.I would pour 3 qts of kerosene in and 2 qts of cheap oil and crank the engine. Just have to let it...
I did mechanical work for a buy here pay here car lot. There is nobody cheaper than them. When I encountered a sludged up motor, I would put...
Use a 6 point socket and remove the two block plugs. Then buy two 1/4" NPT brass radiator petcocks and screw them in the block. Next time you need...
Yup, here they are.
New Solid Mechanical Valve Lifter Set (16) Fits Chrysler Small & Big Block V8 | eBay
Excellent! Thought he was going on the the coffee shop for a doughnut on that last one.