Separate names with a comma.
1994 is correct. Kim
I’ve only seen cable. Kim
Yes, but they are pretty tough. Depends on how hot u got it. How does it look inside? I would be worried that the race/cup didn’t fit properly...
How is the housing inside after all the pounding. I don’t think I would want to use it now. But it may be fine. See if u can get some...
Yupper, that’s what I use. It’s a wonderful product. Kim
U could try loosening off the brake backing plate a little bit. That may or may not help u. Kim
1967 A,B,C. 383 4 barrel. Kim
I just have to ask, did u take the axles and crown gear out etc. Kim
I use these. Kim[ATTACH][ATTACH][ATTACH][ATTACH]
Can u post a pic of the lever on the tranny. There is a few different lengths. Kim
Here ya go. This is a factory dodge carb so it doesn’t use the Holley adaptor. Kim[ATTACH][ATTACH][ATTACH]
Yes it moves it out, but I had another look at ur pic and see ur kit has 1 cable above/ below the other so it may not work properly. The factory...
All u have to do is ask John Cope about the cables, he hates the Lokar the most. I’m not prejudiced I hate them all. Kim
Ok, u need the Chrysler throttle lever adaptor to put the linkage in the proper position. Holley adaptor # 20-7. Kim
Post a pic of ur carb brackets please. Kim
What did u use for the line pressure adjustment? As in zero turns from the plate or u went to 6 turns or somewhere in between? Did it Gsve a line...
I would check the pressures, then report back. I suspect the line pressure is to high. What is the front band set at. How many springs in the...
The 8.25 in an A body all had a 7260 joint. Kim
If u send me some pics with what u got and some measurements would be great. Thanks. Kim
Glad to hear ur getting it sorted out. Kin
What car and what tranny and from what tranny to what tranny. What problem r u running into. I know I had a hell of a time when I went from 6/904...
From what I remember No. The 904 is a smaller then the 727 so the cross shaft has to be longer. And I not quite sure on this part of it but I...
U could always by axles from the Doctor. There around $300.00 for any legnth u need. And they come with bearings installed to. Cass is da man!!! Kim
I agree. U still need to be well past the bushing in the tailshaft. Kim
There are different legnth yokes with different legnth splines in them so it’s hard to say. Kim
I get both ends 1350 and a new tube. Kim
I would think anyone that builds shafts should be able to set u up. Kim
Not by far. Kim
I would get the right 1, like u say 26-45. Kim
Send me a p/m for my email Kim