Separate names with a comma.
Except all of them are the wrong thread. But they are cool.
Hey glad it worked out for you. Once you attack it, in the end you realize it ain't that big a deal.
I own one that for sure was not outfitted with shoulder belts. Mine was a 1968 fastback Barracuda built in Sept 67. Here is a thread on how I over...
No your right they are larger on the outside. I may have a door like you need. But I'm going to be out of town for about 10 days
That is a shame. I have a semi trailer full of Dart rear seats.
Yes the shoulder belt mount position is in front of the coat hook hole.
Start the studs before you tighten dash bolts. Just in case you need to move it around a little to start the studs.
As shown in the picture above, the shoulder belt anchor should be in front of the coat hanger location.
My Black 68 pad was $260.00 from Classic. But if I remember I had a discount code at the time. This was 2017. Great quality.
I bought my new pad from Classic Interiors. I believe they sell the 67 pad. The pattern is unique on a 67 but you can use any 68-76 pad if your...
Great minds think alike, Eh
Yes, That is the way my 69 Dart and 68 Barracuda is. All that is there is the headliner teeth, then the windshield gasket flap.
My 69 Dart doesn't have a trim piece either. I don't believe yours does either if your referring to the location 1969383S posted a picture of.
I'll just add that there is two, one on each side.
Here are a couple of pictures. This is a second one I cut. All you need is to cut a piece of plastic to seal the hole. I have one just like it...
Usually after it blows a bag of leaves and trash in the car.
I'll get some pictures tomorrow.
Heater delete cars had the passenger side vent box. What I did in my 68 Barracuda when I deleted the entire Heater core box, was cut the heater...
Just paying it forward! You guys have helped me more times in the past than I can count!
Yes I just went thru this with my 68 barracuda. Here is the original thread and has some good suggestions if in fact you car doesn't have the nut...
The Metal tabs have to be ground to metal for the bulb to light.
The 4 little prongs are your ground.You can use 57 or 1895 bulbs.
If you need new ones contact dart4forte.
Center belt uses the same bolt locations by the center hump, so adding a third one is no big deal.
Not that hard to swap out. There are a few steps you need to follow. I would get a manual.
I don't see where it has been mentioned that you will need your tail shaft to have the two mounting bosses for the flat shifter plate. Here is a...
Your the winner of the chicken dinner. I did something like you suggested. I cut two pieces of 1/4" plate, .750 wide x 1 1/2". Use a 25/64" drill...
I'm sure someone has a parts car to take the pieces off of. I would try and purchase the two small pieces and the complete mechanisms off a...
Also the threaded hole in the top there is suppose to be a round piece that locks the seat.
There are two metal tear drop looking pieces that go on the square steel nub stick out of each side. They are held on with a set screw.