Separate names with a comma.
every 1/8" is 2 degrees.
round that center divider off but don't make it a sharp edge. pull the sides of the intake back as far as you can without going to far, leave at...
rebuild the regulator.
I think you went the wrong way on the air bleed size.by making them smaller you get less air into the circuit so you richen it up. to lean the...
a bog is generally a lean condition so with that in mind l'd say you would want to check out the power valve which at 12 hg. it will stay shut...
glad you found the problem. put a dab or two a moly paste on each end of the new push rod to help break it in.
your fuel line size is just fine. what you might try is holley blue or black pump just after your rear filter. you'll need to use a regulator sat...
how much is methanol in the barrel?
looks like you got all the answers to your questions so go for it. make sure your fuel regulator is alcohol friendly.
it looks like the bowel is cracked from the 11 o'clock position to under the mounting bolt.
pressurize the fuel tank to blow the gas up to the pump.
larger number pv is needed. the cruise vacuum is keeping it closed to long. a pv closer to the cruise vacuum will open sooner when the signal...
oh gawd my heads hurts after reading all this qwrap.
have you considered changing over to #8 or #6 all the way to the carbs? it would be a good idea.
there is a little rod that has to be held up just a bit so the pump lever can get under it. this is what drives the pump. if you don't do this the...
super glue it back on.
cool, expensive but sweet, just remember to ground the metal top to the body.
ok, here's what is happening. when the secondaries are opening there is not enough fuel being pulled into the boosters. which means there is not...
scrap the highest vacuum reading thing and put all the idle screws at 1 1/2 turns from all the way in. lightly seat them only. with the motor at...
where is it leaking exactly?
I don't think so. check to see if the spacer broke, also check the plugs, wires and the timing.
don't reckon that will work with gasoline.
soak it in wd-40