Separate names with a comma.
If it had an electrical connector, there was a maintenance reminder. Dont recall what car used them.
Or it could be a unit for correcting a...
Not springs at the back,but 2 thin wire hooks. I found mine hanging at the back and tucked them in the box with my new headliner. Best to glue...
I will be heading to a marine supply for some good quality outdoor carpet.glad all i need is black.
You could end up making multilpe patches when one complete floor pan would solve all the issues with a little more work.
Pullers are cheap and useful for so many other things.
The harmonic balancer puller kit has everything you need,and its many other uses make it...
Tou have to pull the whole works out. Start by unbolting glass and push it up to top and tape glass to stay. Duct tape up and over.
I built a box for my flat screen tv to sit on,and to hold the center speaker, i sprayed it with paintable undercoating and a couple coats of...
I repaired one using mar-glass. To get the pebbled finish i used the sticky side of duct tape. Once i painted it, was barely noticeable.
A little grease on the c-lock will help,and a LFH.
Instead of a BFH.
There is a gasket that goes outside between lock and doorskin. Is it missing?
That would be part of your rattle.
Its not just you, the locks are...
I did this in my boat. 40 watt booster/equalized. It makes decent noise, wired to come on with key and all i have to do is plug into earphone jack...
Simple green. Go figure. Gives me hope.
I was talking to the local upholsterer, there are plastic sheets used instead of wood fibre.
Im thinking i will try it.
My barracuda got that. Im going to do everything in my power to prevent that.
My cardboard is shot too.
Not sure what im going to do with it yet.
I really want the panel to lay flat when its open.
Thats my preference.
My dash was hacked when i got it.
I like my tunes and i will install something to make noise.
I plan to paint dash,so hopefully the black will...
When i revisit the dart sound system, will be a pair of bose bookshelf size speakers i think.
I had my house speakers wedged in there,big ol cerwin vegas. pioneer gm 120 driving them and an under dash sony tape deck. That setup rocked! I...
Shaping is done in a variety of ways,using sanding wheels on a die grinder is nice for contouring.
Its a slow process.
Finding the right density...
I dropped one. Took out the screws and it fell on the carpet and broke in 2.
I would think they are all brittle.
I plan on sheet metal replacement.
They look nice! Hope my dart seats come out like that.
I will be pulling covers and getting the local upholsterer to do them. I will instsall...
Have an upholstery shop join the two pieces.
The finished edge on carpet is easy to do,and is hardly noticeable.
To fit it,it either needs to be molded or it has to be cut and sewn. Its not easy. The two piece ones usually have a finished edge.
I prefer cloth seats over vinyl.
Many times i put a1” block under the front for more comfort.
When i was at the ford dealership, had to repair heated seat elements. Leather seats are tough.
One trick i learned later is put poly on the seat...
I’d do it myself.
You need good grip and hog rings/pliers.
If you took them apart, then re-assemble in reverse order.
Theres no worries about...
That looks diy. Very ingenious.
Using the trans shift lever makes it easy to adjust.
The one i cobbled up took 4 attempts before i could hit all...
The slots in front brackets allow for height.
Rear of console screws directly to floor.