Separate names with a comma.
If the truck hoses are long you may be able to cut them down and have Napa crimp the correct ends
back on them?
Good to know.
I have probably been thinking the slant six used the same spacing as big and small block for 30 years.lol.
3.250 is a match.
The box is marked chrysler 383-413 60-66 in hand written ink?
I checked fit to a big block housing and spacing is correct for that. I have no...
I got 5/8" tubes on my heatercore.
Says capable of 10,000 rpm.
I won't be spinning it that fast.[ATTACH][ATTACH]
I've seen where guys would use masking tape of the needed width to mark the cut line on the blade tips.
Keeps the fan in balance if blades are...
Cardboard in front of radiator.
I know its tacky but it works.
Does your car have a aftermarket mechanical oil pressure gauge?
Could be seeping at a fitting and trailing down a cable or wire.
I like this response best. Intelligent and sensible. You would need a different car to utilize
some of these mentioned fixes for a problem that...
Yes I have used dilluted lye to strip the anodizing off my grill surrounds. It definitely has a reaction to aluminum.
I did do quite a bit of searching on this before I posted my problem and you are very correct.
I would say 99 % of the rust removers I read...
After a ransak of all the little lady's cleaning stash I didn't turn up any of the products suggested above. Looks like a trip to the store is in...
Here's a photo of Al's Toy in action just for fun.
I picked up a race hemi aluminum water pump housing and have been working on getting it
cleaned up to go on my engine.
I got this housing from...
I would go 3/4 to 1" all around clearance. And half of the fan blade in the shroud.
That strap is a real good idea with the rubber mounts.
Solid or rubber engine mounts?