Search results for query: *

is there a car in that pic

But im sure if you start a wanted post you will find one closer

I have a used one...but shipping might be a few Pm me

Just find a pre 70 dampner Then confirm that TDC(#1cylinder is all the way up) lines up with TDC on your dampner

Yes everything would bolt on Funny that its a 69 timing cover Either its a late production 68 and they used a 69 cover Or who did the swap just needed a early pass side timing marks cover

Ok gtx makes up for it

It like detective work need all the clues The timing cover is a 69 only 70 they changed the side the lower hose came out So some were would think an engine swap was done Maybe they changed the t cover then

I can't believe that to be true Do the last 4 match your serial #

Ha sad .. Sad I couldn't sleep doing anything like that Even if the guy was a scum I still treat people fair ...if they are scum I will just not deal with them

Need a 68 or 69 dampner Can use the 68 cover but need the bolt on timing pointer

Funny that's a 69 only timing cover

That's a beautiful restoration

Ha and it only has 5 miles on it Yet the tires are bald

Cool old truck Is there a hole in the firewall next to the master cylinder? For the clutch master

woudn't run it without the balancer could end up cracking your crank just cause it hasn't yet you need to tie together the frame rails where the old org bell housing trans mount were when they moved the rear trans mount think they make a kit ...something about the flex in the rear spring...

Nice I had to build one of those years ago

I was thinking where the bell housing bracket Was by the starter

20years that's a 03 till 05 passat

Yeah it was nice cause my taxes aren't bad Waiting till they re assess it

yeah been collecting ho...i have a hard enough time seeing that

rust is still on the inside ...they rust from the inner foam nice for a flip ...give it a winter

what about glueing it old man i know my body guy glues rocks/quarter on so you don't expose raw steel not the way ma mopar did it but the latest and greatest way

lot of small block chevys are down by the crank..... that looks like a bosch sensor make sure the wires are shielded high voltage will f-with those

don't think stainless likes anything to stick to it and too hot it might get brittle not 100 % sure of the fitment ..but maybe garage door cable come with the crimps

I would say my previous owner depreciated my shop It was a dump....200k later and just a little less then a dump

The stupid stainless steel capped lugs They swell up what a pia My fav are porsche titanium lugs Feel like plastic

Shhhhhh of course......

Yes good point I do 1/4 payments ....hurts less Or open a tax account so you can collect interest before you give your blood and sweat

its even harder to do it right after it was done wrong

sweet gtx ...you still have the 70 ?