Search results for query: *

I knew it didn't look right, but couldn't figure it out.

Looks good! I see someone added the 65 Dart Gt lower fender/door louvers:thumbsup:

Excellent, screws look good. Glad you got it figured out.

Sorry man, I got your thread confused with another asking if boot was installed over or under carpet, and the screws. My 6 screws look to be factory #8x3/4" with captive washer. I have remnants of an original boot with smaller holes than the repop boot. That's why I added small ss fender washers.

I cant tell you what is factory correct, but when I replaced my carpet with new mass backed carpet I cut the shifter opening out and put long push pins in though the carpet to locate the holes for the boot. Then used a pencil tip solder iron to burn/melt the screw holes. I installed the boot...

Thanks! Have a good one

Unfortunately I Do know what that is. I threw mine away while replacing my carpet, thought a previous owner had made it:BangHead: Mine had the clips cut off and was attached with velcro. I have only seen 1 other picture of a car with one since. This was on my 65 Dart Gt 4 speed car. Its a scuff...

That should work, good luck!

On my 65 Dart buckets the spring wire hooks directly to the j bolt. Doesn't look like yours will reach?

That reminds me, I need to call Doctor Chunk and order a gearset.

Very nice, you did well! Enjoy the ride.

I'm not familiar with a 68, but won't the coupler seal come off and go on from the other end of the shaft with everything disassembled?

I traded a HiPo air cleaner on here that actually had a aluminum "tin" with a printed call-out. Not a sticker. It was attached by adhesive.

Thats how I did mine, except used a soldering iron. Also, the way the old carpet was installed.

I'm less than 100 miles from Cleveland, Buffalo, and Pittsburgh. I'll keep an eye out for it.

I believe the donor for my front brakes were from a 70-72 dart.

My 65 Dart had Kelsey Hayes disc upgrade when I bought it, calipers were shot but the 8 pistons are stainless steel. I bought replacement cardone/ Kelsey Hayes calipers and was going to put the stainless pistons in but they were a few thousands smaller than what was in the new calipers. So, I...

Agree with your recommendation, Used the exact primer on my Jeep Cherokee project. I just checked, I bought on amazon in 2023 for $24 a can and again in 2024 for $16 a can. That's a good price right now.

I think he has the pleats spread to show the bottom. Looks good to me.

Lol, did the same with the wife's Jeep Cherokee twice! Left the hatch up and shut the garage door.

Hi Grumpyb tried sending messaqe, your inbox is full.

You could try a splash of each in a small container with some rusty nuts and bolts.

Bought a new Sportster xlc in 2004. Sold it last year to help pay for Mopar stuff. It never leaked a drop either!

That's what I had to do on my 65 Dart, Drivers side not to bad, passengers side is tough.

High torque band clamp for exhaust

This is the replacement at Brewers. PENN GRADE 80W-90 GEAR OIL GL4 QUART - Mopar A833 4-Speed Transmission & Component Specialists

I think Jay was parked right behind me, I remember the 3 speed:thumbsup:

Congrats Ron, Nice hotrods, I was there in my 65 Dart Gt.

I plan on taking my 65 Dart GT Last year the weather was crap, cold and wet I remember, so I didn't go.

True! its a beauty