Separate names with a comma.
Since the fitting is already buggered you can try vice grips or a small pipe wrench but you run the risk of damaging the trans cooler if your not...
Look underneath the vents, there will be two holes with nuts way up inside. I think they are 3/8" or 7/16"
The hubs are always steel, the blades can either be aluminum or steel.
At least it didnt take out the hood.
In the pic is a marine water pump housing for a double impeller pump, the pump mounts to the "C" shaped part hanging off to the side. The hole in...
The bolt spacing might be the same but the opening for the fan is usually offset.
Thats probably the wrong hvac control for that trim piece, or could be the wrong trim for the dash.
The trim piece has two studs on the back which go through the dash frame, the heater control mounts to the trim from behind with two nuts.
This would look way cooler than an electric pump [ATTACH][ATTACH]