Separate names with a comma.
I had the same issue with my 340.
Cleaned threads twice with brake cleaner and a wire brush that is used for cleaning rifle bores, then I ran a...
Twice burned, three times shy!
I had two of them they were both junk, throttle struck on one them, I never could get the other to idle. I know from experience that Summit...
I hear ya, I also am going through some healing after a heart procedure.
Very much interested in a pair of seats for my 67 Barracuda.
What do you have in a pair of high back bucket seats?
Top Sportsman Driver Jamie Fowler Opens Up About Armed Robbery, Theft of Racing Equipment
I assume that members have learned to trust your every word as the truth. LOL
Ouch X 3
Lesson learned the hard way.
For a street application - dont waste your money. Research this forum regarding problems with roller cams in SBM's.
I would ditch the valve covers first.
Perhaps find a stock pair of covers with the factory PVC and breather arrangement.
Hell put a Wanted To Buy...
OK is the right side the passenger side or the drivers side?
Send me a PM please if you would like to get rid of the Sebring seats
Don't be embarrassed I don't think that is the OP problem.
My 340 has a rearward mounted breather on the passenger side which is directly...
Does your engine oil thru the push rods up to the rocker arms?
Do you know if there have been any oiling mods made to block?
Check with your local VoTech school for your body and paint.
A gent I know had his 65 GTO done by the VoTech and it looked really good. All it...
First I love the truck, what year?
Have you run a compression check? If so what were the readings?YR do those look like the correct rocker arms...
Is this a new build?
Or is this an older engine that developed the problem after some miles? If so how many miles?
How much oil is in this...
I believe you may have something confused here.
You state that you are running " a breather cap and tube to the carb"
- If you are talking about...
My long time mechanic buddy got to old to get off the floor so he had a carpenter come over and coffer the ceiling in his shop, now he has a lift...
I would contact TCI customer service direct, they are best to help figure out your issue.
I had a Lab that got kennel cough at the Vets office, dam near killed her.
Very tough to get shed of, count your lucky stars that your dog is OK....
PM me if you still have the front seats.
Take the money and run, you could get run over by a bus tomorrow an never see a dime of it.
With a piece of plexglass you could have a hell of a nice coffee table. :steering:
On my 512 Satellite I had to run a full length negative cable from the battery direct all the way to the block. Running it thru the frame did not...
You could be right
But I would still add more initial timing (2 degrees at at time) until he finds the sweet spot.
I have never run an engine at 8...
Bingo - your initial timing is 8 BTDC.
Should be more like 18 BTDC.
That is how I start my car.
I installed a separate ignition switch so I can kill the box on start up so I can first prime up the oiling system on...
Dont waste your money on a roller setup for the street. Stick with a solid flat tappet cam from a reputable manufacture that grinds their own...
You really are "living on the edge"