Separate names with a comma.
The M72 std vol has a 70-75 psi bypass spring in it.
Just here for the comments:popcorn:
Good on ya for questioning it, better to be safe than sorry. I always went under the assumption of notches down and to the left. Never looked...
Some did (4bl)some didnt(2bl)
Then you got the right one. Our cuda sounds awesome lol
I have same cam but solid in our 67 273, 904 323sg. A combo of too much cam, not enough gear and converter in my case.
No bottom end.
Well if they are available new aftermarket...30-40% of new would be my price.
Not available? JJJIf you have mounts/brackets and insulators everything in good shape I would say at least $100.
Pic of a pic. Lori got my pic framed for me. It's a pic my neighbour took a couple years ago of our 67 cuda with Dad(RIP). He gave me the beauty...
You want to ID what you have and continue using it?
And then swap to a magnum?
Make sure to rtv/seal them(you already know that tho)
I used POR 15 manifold brush on paint, works great.
His dart in his other videos is gorgeous!
His name is Bob/Robert Mills, aka Superdart340 or Superdart426.
Interesting to see what combo he goes with, I'm confused (easily) already.
Google bouchillon performance. I've heard and seen lots of recommendations for them.
Nice, congrats! Thanks for update!
Those are some super consistent compression numbers! I'm not sure why, but they recommend to have carb fully open when compression test.
Drain your oil and filter it to see how much glitter?
No matter what the issue is, a teardown is involved to diagnose the "glitter"?
Welcome aboard. Lots of good advice here. As mentioned magnum swaps can be done, but are not a direct swap. With your admitted limited mech...
If a rebalancing will need to happen I would look into the cost associated, it may not be cheap.
Cost of new rods and a balance?? You can get...
If you read a few replies up, problems solved. Outta time.
I've never seen a pan as smooth as a machined block. You even said your pan needs hammer time?
Also, it's to help hold it in position. Try it...
Heres my thinking, oil pan rail on engine is a smooth machined surface. So in my mind shouldnt require "goop". Pan surface is not so smooth, so...
Math might be simple, but the time it takes to come up with numbers to plug in??
Gotta weigh every single piece right?
Maybe...but if they are lightening it, they are removing metal correct?
I've never heard or seen a balance quote on a piece of paper. So I cant...
Question....I'm thinking that the main cost in balancing is the labor in weighing everything and the computations as opposed to the actual machining?
Doesnt seem to be a lotof specs on them but they all seem to be a great price.
Wow, great prices.
Thanks for posting.
Cley, I asked my machinist at Car Quest(I bought a 70 340 short block from) and he ballparked the balancing at $600.
Where you are makes a...
But if you are talking ratio, how does the differences in volume make a difference? It's a ratio so the differences/changes would be a mute point?...