Separate names with a comma.
Dynamic, Ultimate and PTC all have excellent reputations. I had my converter redone by Pro Torque. Drives like a normal car but will allow the...
Na, it’ll be fine.
Whoooa! Non Stock ... LOL
:steering:Oh, sorry, habit....
The thermostat should sit in the housing with a little play.
Between the large and small thermostats, there is a big difference when there...
You may have ether the later thermostat housing or later thermostat.
OK, the Edelbrock Performer should use the older style water neck, thermostat & gasket. This particular old style thermostat measures 2-31/64,...
Ok, I thought it ya have been a stock intake and manifold, hole in a second.... BRB
What year and take manifold and engine?
You must have a lot of experience then.
Yea, that’s normal, welcome to the one size fits all header and crap quality control care issue we have been dealing with in those types of...
As in not degreed dot to dot.
On the 727, it is possible but expensive.
The MP draw back....
Didn’t Harold himself say his cams like 4*’s advanced? Even the older UD grinds?
This should do the trick; [FOR SALE] - 1974 360 THERMOQUAD CARB.6453s
With lifter preload, less is less duration and later activation. I do this on small-ish street cams. I have run as little as .010 preload. It...
Yep Yepper!!!!EZ 2 miss with long AJ like replies.
That’s actually a good set up.
The 110 is indeed. It doesn’t fit everyone’s build, ideal idle, etc... I’ve seen this stated a bunch of times.
AJ did a comparo between my engine...
X’3 here. In a heavier car (E body) 2.66 first, 4.10’s and a 27 inch tire with a big street cam, single plane intake, etc... the car wasn’t to...
Depends..... “Need” the kit? No.
But it would be a good addition and benefit.
This cam below and a worthless FWIW, this is as big as I would go for myself in a low compression 360. For myself, it boarders uncomfortable. A...
On the nose like these cams below;
Gotta link to that part? Thanks.
Oh crap! Thanks PRH, my bad and good mention for the rocker ratio and lift stuff.
Yes! They do and man was I surprised by that!OH! P.S. I’d rather the correct cam, but I’m not sure how you wanted to go about it.
Stock heads? Valve sizes?Mike, I’m personally not crazy about the 112 C- line. Normally these like a lot of compression.This may not be a...
No, most cam company advertising is at .006, the underlined number on the far left. .002 is a super small amount of movement.Then, this is my...
.002 tappet rise is 292/301 - not worth much
.006 tappet rise is 255/262 - most commonly listed
.050 tappet rise is 222/229 - industry standard