Separate names with a comma.
750 demon flows around 830. The venturi is around .1 larger than a QF or Holley 750. If your racing the 500 an 850 demon or larger would be the...
OP send me an email address and I'll send you an old 3310 tuning article.
I have the opposite issue, et hp calc is always higher than mph hp using Wallace Racing HP calculator. I think the aero of my brick has something...
You need to adjust/center the secondary butterflies so they don't hang up when closing. Idle mixture screws do not have to be the same. Every dual...
You need to read, not make assumptions, and stop calling me a liar.
I will post whatever I want if I think it will help someone.
Bingo! Pistons are .018 above deck. 10:1, 7.81 DCR car hauls the mail.
Here's a calculator with altitude input.
Boost Compression Ratio Calculator
I never stated my DCR, simply wrote what my last compression check was. A compression gauge is for checking engine health. My gauge is not...
L2316F40 deburred and polished top
66 cc chamber deburred
25 initial 35 total mechanical
run a good cooling system and proper AFR
Read this article. You can download the calculator.
I run a 340 10:1 J head at sea level on 93 with 282S, 185 crank psi
You need the extra...
Agree. Also make sure the Idle air bleeds are clean!
If you are running in the 2500 rpm and lower range you are using the idle circuit.
Make sure the float levels are stable and in the middle of the...
If you haven't already, you might want to disconnect the fuel line and do a flow check into a good size container.
I assume your heads are low mileage. Why not port what you have. I have a 300 HP crate and a mild port and bowl cleanup made a big difference.
did you degree the cam?
what is your rear gear?
are you running a stock converter, 4 speed?
Look on Craigs List. Mustangs Ford run the same bolt pattern and you may find a slightly used pair mounted on steel rims.
Drive around the water. Lower air pressure to 16 psi to start. Feather the throttle. BFGs suck.
MT ET Street drag radial 26 Diameter will hook you...
http://www.forabodiesonly.com/mopar/showthread.php?t=322621Above link is MRL's 340 stroker built for pump gas and street driven. This motor with...
I use Camsheild additive and it is cheap and works.