Separate names with a comma.
You should subframe it while you have it up there.
Sorry for your losses
Wouldn't it also depend on how well your tires hook up ?
I had the same thing happen to me, the fuel went between the paint and the car and lifted it off. No booster, just gas. I don't know who painted...
You may be better off getting a later model set of locks. they are flatter a lot cheaper. BUT you will need to do some filing on your doors to...
I saw a review for a Vulcan, and it said it is a good welder, but stay away from the HF flux core wire, unless you like the spatter.
I hope I am not high-jacking this thread, but I pulled a drum off of the back of my 64 dart, 8 3/4 10" x ?, because it locks up when I step on the...
Check the return holes in the bottom of your Master cylinder. I have had debree / rust plug up those holes and cause the same situation.
Breaker Bar : self explanatory, Used to break off that stud that has a stuck nut on it.
Could be the intake gasket and not the heads, run a pressure test on the coolant system.
Scored these on Ebay
14x6 and 14x7
What kind of wheels are you looking for and what centerlines do you have ?
Why didnt you get the smart ones ?
HMMM, Oddly enough I cant find the original post to end a PM where is it?
I run 215 60/14's on Stock rallyes all day.
Yes but will a 14 inch Rallye clear it ?
Yea 4th gear is a little more noisey on mine also
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
is it possible that the rear offset is more than the front offset ?
Fast idle can be a symptom of an vacuum leak. Check for play in the throttle shaft going into the carb. You can also, with the engine running,...
try to find one that takes 64gb or larger micro sd
I put one with wifi in my wifes car, it work really nice and you can get to the video's from your cell phone without having to touch the camera.
some sanding is probably necessary no matter what you do.
Let me rephrase, in neutral with the engine shaking give it a quick rev and let it return to idle. then see if the shake has lessened. Do the...
I have the same setup clutch wise and it definitely causes a shake, which is remedied by revving the engine. but like AJ said it is just...
your not running a centerforce clutch by chance are you ?
What wheels and tires did you go with ?
I broke my cam in with the stock 340 valve springs, on my 284/484 cam, then left them in. they seem to be fine. but I also have Rhodes lifters .