Separate names with a comma.
NOS clutch for my '69 Cuda with factory AC.
Sounds familiar! I grew up on a farm but got a Mech Engineering degree And spent my career in a nuclear plant so have a good understanding of mech...
Bodyshop has the QP's screwed in place to check all alignments. The QP's had a slightly flattened profile maybe due to shipping. The bodyman made...
Did some restoration work on the shifter.[ATTACH] [ATTACH]
Disassembled the front suspension the last few days. Removed old LCA bushings and will be replaced with Moog K791 bushings. Changed disk brake hub...
Anyone have any photos or knowledge of the original color of the disk brakes splash shield? I believe they were painted black at factory, but not...
Anyone have any photos or knowledge of the original color? I believe they were painted black at factory, but not 100% sure
Repaired the drivers frame rail. Cut out rusted pieces and made new ones and TIG welded.
He is now working on the trunk lid. Usual rust along the lower lip. Found previous "repairs" consisting of fiberglass and bondo!!!! He is...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Some more photos of body repairs.
[ATTACH] [ATTACH] [ATTACH] [ATTACH]
Also keep in mind that some timing lights will not give accurate timing results if a MSD is installed.
The hydraulic lifters cant be pushed down via the pushrod because they are locked full of oil. If you have any looseness, then likely the cam and...
Looks like fatigue damage similar to what I found in my 340. I had used standard 1484M bearings. This time I bought high performance SH875S...
ThanksOver the years I've come to expect refurbishment/restoration "challenges"!!! Frustrating at the time, but enjoyable in the end!
Body shop has the other QP off. Repairing various rusted areas. The worst part was at the bottom of the drivers side B pillar. When the outside...
The spacer will also work - as long as you have the hood clearance!!! I had to use a drop base on the air cleaner to get the Performer RPM and...
Picture after milling mine down.[ATTACH]
Because I'm going to use an Edelbrock Performer RPM, I asked Holley Tech Support this question and this was their reply:From:...
If a dual plane has a center divider full height, it will need to be cut down about 1” for use with a Sniper
The shim is not only subjected to high temps but also to the exhaust pressure pulses. .002” copper will not withstand the pulses. I use .015-.020”...
Turquoise blue - yes correct for 69 340. Mopar Engine Paint Color Guide 1960-1974 - MyMopar.com
Where did you find that??
Yes - using XFI as well
Started to mock up some of the parts to see how everything fits with the Holley Sniper and Hyperspark distributor
That is a stock 340 windage tray.
No. It is an Edelbrock Performer manifold