Separate names with a comma.
Asking for a friend who has a 67 barracuda. Problem is when he gets on it the front end rises up but stays up until you roll car or push down on...
Update- Finally got around to getting 2nd opinion on x block. I sent block to Bill Richardson in Lynchburg VA. I had explained over phone to him...
Im sure 14" but you can contact him at 920-973-0196
Posting for friend. He is in Two Rivers WI.
No info selling for a friend. Contact bill at 920-923-0196 text only please.
I understood your comments and was only curious about rumblefish's comment that he has seen/heard of more than a couple being only able to go to...
Transmission cooler with filter. $25[ATTACH]
68 Barracuda tailight lenses. One is chipped. $100 obo.[ATTACH]
67 Barracuda tailights complete. $250[ATTACH]
Thank you guys for your inputs. I really appreciate it. So was there different patterns used for castings that made some thin bore and somethick...
Well thats what i always understood as being the case. I thought it would be very unlikely they would use a different pattern for casting x...
So they cast x blocks with different patterns?
Small bolt pattern spare tire in good condition. $25[ATTACH]
Ok had my nos x block at machinist to have 4 bolt mains installed and line bored. Was told the line bore is way off and that bores were sonic...
Thanks ill check it out.
Looking for non tinted drivers door glass and left quarter glass for 70 dart 2 door.
Looking for good used factory roller cam for 1999 or 2000 5.9l magnum.
Well thanks everyone for your responses. I'll check into your suggestions. Hope Ryan is ok. He treated me well and seemed like a nice guy. His...
MMy brothers project.
Thanks l talk to him..
Thanks for input..I would strike borchardt off that list but thanks.
Don't know what to tell you always answered mine before as well.
I liked work but hes not responding to emails about doing them and it took 2 yrs to do my w5 heads.
Who has had experience getting w2 iron heads ported and by who. Had my w5 heads done by Ryan at Shady Dell. Thanks.
Please let me know of quality machinists in wisconsin. Please have experience using them at least once. Thanks.
Do you still have or make bushings for clutch pedals?