Separate names with a comma.
It should just slide right out, you may have to loosen an intake bolt to get clearance, lay a work-cloth in the valley to avoid blemishing the...
If you have early stock heads, it's possible to pull the lifter out without removing the manifold.
Then take the lifter apart, clean thoroughly,...
When you shut the engine off, a few valves will be open, and under spring pressure to close.Those lifters may leak down while stopped, and when...
I think you are fine .
I would have liked it a bit more engaged into the trans.Having said that, - if it were. MY car, I would try it , expecting a possible...
Where do the splines start on the inside of the yoke ?
Do they start right at the end, or do they start an inch or so down inside ?
My "parts guy" has been thru half a dozen " different outlets " in my area.
I've followed him since the 80's. - all over .
I always get the right...
I've ordered and received a coupla dozen sets of Doug's over the last decade, from Autozone, for the discount and free shipping.
There have been a...
That's why I supplied the link.- to cover the "etc" lolCheers .
Fastener Foot-PoundsAxle Shaft Nuts (tapered axle end nuts) 145 (min)
Brake Support Plate to Housing Mounthing Bolt Nuts 30 to 35
I've had the opportunity to drive mosta the shifters mentioned, not all.
I will say, after driving them all, I've never found one I prefer over...
I know it's automatic, but did you accidentally "miss a shift" causing the engine to over-rev, - before it ran shitty ?
Still have the 69 - 340 Swinger I bought new, so no regret there .
Married 48 wonderful yrs. to one wife , no regrets .hmmmm -I Wish I'd...
Go look on the Legendary site.
I got allmy Swinger stuff from them, they had great pix
I think GTS interior was different, jmo
Be aware of a number of small selective fit shims, under the balls, used to center the trunion.
They are easily overlooked, and lost .
Had B&T in my 62 383cu/343 hp Wedge .
12.39 back then .
MOVING WHEELWELLS 101There's lotsa good stuff that may help you ..frame connectors, brakes, suspension .Tech Index
Lotta boaters with raw water cooling, think sea/salt water doesn't freeze !IT DOES ! !
Take a length of elec wire, strip each end, use vice-grip or similar and clamp one end to trunk lock striker.
Take the other bare end, and touch...
I've had air shocks on my 69 - 340 Swinger since new !
At the track, I'd lower them down to justa few pounds to pre-load the rear suspension, a...
Pull the plugs, one will look different.
Then pull the valve covers looking for a bent pushrod, broken rocker, worn cam lobe, on the cylinder with...
It's a Mad, Mad, Mad, Mad World .[MEDIA]
I found a fastener that is like a large head pop-rivet, but with 1/4 nc screw thread, works perfect.
It also brings to mind some drywall picture...
It's possible for the bell housing pivot to be located in a manner that the fork lever will interfere with the top of the collector, needing a...
Steering Box Info
Did you ever measure the distance from the disc to the fingers to find if they were different ?
That'd give you a hot spot .