Separate names with a comma.
clean set up
This is where I’m at.
lots done ,
Lots to do ....[ATTACH]
I will probably lay the harness in the car and get started piece by piece.
Would you happen to have any detailed pics of your engine...
I am looking to do the same set up you talked about. What wires at the bulk head connector did you ditch ? What do you need ? I will run a GM alt...
it sounds like the small section I am talking about is the ‘ engine ‘ section. Coil eng temp oil psi and alt. I will be using a aftermarket three...
Now a 440 / 727.
going to use an internal reg alt.
MSD style ign box
Stock style dist
Ok. So I am ready to tackle the engine bay wiring harness that was in a box ,in the trunk when I got the car. Spread the harness out on the...
contour fans ?
pic or info
My Harley use to do that. !
A few things add up.
Single plane intake ( high rpm)
Low gears NG
That cam ( high rpm)
Exhaust manifolds NG
That is an Awesome truck.!!...
N I c e. !
yup. custom !
street car. < 6000 rpms.
Tight space.I hear people say they fly part ?
Is that true ?
They say tested to 9000.
3” with dumps.[ATTACH]
Just a question ,
Why is everyone so against a flex fan ?
( other than being sharp edged )
Asking for a friend. LoL :rofl:
NICE truck !!
proform. Jegs,summit ....
I have seen these as well. Around 250 shipped Let us know if you get them , and if you like them
thanks , I have decided to go another route. Petronix is up fir sale if you know anybody
New In Box. Petronix ‘drop in ‘ dist. Never plugged in or ran. Reason I’m selling is it will not work with my aluminum heads. These are very...
Do you know how much you can grind in that area ? Is the head solid there or should I be concerned about how deep to grind ?
Here are a few pics. I have removed some material, but I do not know if the head is solid in this area, or has a water jacket or hollow area to...
I just added 2 pics
If you need threads close to the the bottom of a blind hole , do most of the thread cutting as mentioned , then finish with a ‘ bottoming ‘ tap....
is the head “ thick” in that area ? Can you grind some without getting into trouble