Separate names with a comma.
clean set up
This is where I’m at.
lots done ,
Lots to do ....[ATTACH]
I will probably lay the harness in the car and get started piece by piece.
Would you happen to have any detailed pics of your engine...
I am looking to do the same set up you talked about. What wires at the bulk head connector did you ditch ? What do you need ? I will run a GM alt...
it sounds like the small section I am talking about is the ‘ engine ‘ section. Coil eng temp oil psi and alt. I will be using a aftermarket three...
Now a 440 / 727.
going to use an internal reg alt.
MSD style ign box
Stock style dist
Ok. So I am ready to tackle the engine bay wiring harness that was in a box ,in the trunk when I got the car. Spread the harness out on the...
thanks , I have decided to go another route. Petronix is up fir sale if you know anybody
Do you know how much you can grind in that area ? Is the head solid there or should I be concerned about how deep to grind ?
Here are a few pics. I have removed some material, but I do not know if the head is solid in this area, or has a water jacket or hollow area to...
I just added 2 pics
is the head “ thick” in that area ? Can you grind some without getting into trouble
So I am installing a Petronix dist in my 440 and it just hits the alum head on the pass side. Doesn’t seem to hit by much , but keeps it from...
Thanks everyone !
Working on my 440 69 dart project. Getting to the altenator . I am not interested in a external regulator or originality. I am thinking...
What size wire are you using , and how long ?
Longer run = Larger gauge wire.
How many amps is the pump ?
How many amps is the alt ?