Search results for query: *

Pre t-top loss. Driver side only is missing, shipping company is going to take care of it. Just need to find another set

My dad just bought an Aspen t top. One of the t tops was lost in shipping. Looking for a set, or a driver side if possible. Located in IA

Located in Persia, IA

My dad has a 1977 Aspen with a 225 in it. Looking for an uncracked exhaust manifold. Thanks

Im aware, thanks.

Im missing a single 072 right offset rocker. I will purchase a full set. Thanks

looking for a decent set of valve covers for a 1970 340. I dont get on here very often, please PM with what you have, so I get the notification

I really have no use for this. Make me an offer. Can send pics

This is the last 4 speed piece I have left, Would like $30 for it plus shipping Located in Persia Ia. thanks

figured that someone around here must have one of these old vans lying around. I need the underhood harness and possibly the underdash harness out of a 75 dodge van. I need this for my 1975 dodge wayne corporation ambulance. This is the only thing that is keeping it from running. Please PM me...

grille is sold, the trim plate is still pending.

The following are sold: cowl plugs grille seat hinge pins I will be pulling the next round of parts tomorrow. Im not sure if I will have enough time to get all of it pulled. I didnt expect there to be this much interest. You guys are running me ragged!

pending on the hump and carpet plate

I have this posted all over the internet with no replies. You A-bodies only guys are the most helpful of anyone!

Very tempting, but I would only drive that sort of distance if it were a 69. I am in Iowa. thanks.

Pending so far: 4 speed hump trim plate grille glovebox trim trunk lettering (both sets) bellhousing flywheel and shield from 273 car z bar clutch rod and fender mount from 273 car cowl and inner fender plugs on both cars rear window interior uprights (plastic pieces) v8 center link v8 gas pedal...

I should have this, please send me a pic anyway to show me the exact areas that you need. PM sent replied Gold car is getting pretty stripped, Alot of stuff pending, I will post up what is gone when I recieve payment. Also, I think I replied to everybodys PMs, if I didnt please let me know...

Thanks! Its a start. looking for more of a project in the 2-3k range or under.

Well, aren't any now.

looking for a satellite or belvedere 4 door. Looking for one as clean as possible, engine and trans not a big deal. thanks -Kaleb

Sorry, the center link and the throttle cable are spoken for. yes that is an 8 track, It is very dirty and I HIGHLY doubt that it works. If you want to take a chance on it, PM me and I will pull it for you The spare tire wells are shot on both cars. The seat bases are available, out of the 4...

Here is where the center section of the grill has the tab broken on it:

The cars are located about 30 mi east of CB in Persia. I doubt anyone would buy the seats, only one of the four has good foam, I will take a look at the pins and the adjuster wire and see if they are useable. The shift plate, boot are long gone, the pad is shot, and the carpet guard is already...

just the passengers side on the copper car. The drivers side has a small crack, and a mounting tab is missing on the center section. All useable but I wouldnt if it was anthing but a driver

One more. I have linkage pedal assemblies and a 4 speed hump for sale in another thread.

Not alot of body parts good on these cars. They are rusty and they are beat up. The copper one is a slant 6 3 on the tree car, it is complete. The gold one is a 273/4 speed car, most anything useful has been stripped. Mostly what is good is small interior and exterior trim. Between the two cars...

Pm me if you havent found this. I should have one.

I have what you are looking for if you havent found them yet.

I am located near the southwest border of Iowa, near council bluffs and omaha NE

I need the back seat for a 69 road runner, Im not sure if it is the same from charger to roadrunner. If they are then I would be interested.