Search results for query: *

  • Users: MJD323
  • Content: Threads
  • Order by date
  1. MJD323

    [FOR SALE] Drive shaft

    Drive shaft for sale from a 74 duster. Measurements are as follows: Center to center of u joint: 47 1/4 inches Circumference: 9 1/2 inches Total length: 54 7/8 inches Yoke fits a 904. Front joint is a 7260 (small joint) Rear is a new 7260/7290 conversion joint Macon GA. 100 plus...
  2. MJD323

    [WANTED] Pulley for Federal Pump Needed (press on)

    Hey Guys, I am in need of a pulley for a Federal power steering pump. I already have the new pump, but bent my pulley as it was FROZEN onto the shaft. It is a 5/8 ID press on (no keyway) pulley, 7 in dia. Please let me know what you have and how much. Thanks
  3. MJD323

    Can this be fixed?

    Hey Guys, I have a 418 that was recently put together/fired up and began mixing water and oil. I pulled it back down and on closer inspection I believe I have found the issue. My question is what are your thoughts on fixing this? Can it be sleeved? If this can't be saved/sleeved etc, what are...
  4. MJD323

    [FOR SALE] S/B Torker 340

    Hey All, I have a Torker 340 for sale. I ran it a few years ago but it no longer fits my build. Just needs a good cleaning. Asking $50 plus the ride OBRO. Paypal preferred. Thanks
  5. MJD323

    [FOR SALE] S/B Mickey Thompson Valve Covers

    Hey All, I have a set of M/T valve covers for sale. I ran them years ago with no leaks and they have been on the shelf. I cleaned one to show the 'potential' a little elbow grease could give them. Asking $75 plus shipping OBRO. Paypal preferred... Thanks
  6. MJD323

    [WANTED] 3500 Converter for 904

    Hey, I am looking for a 3-3500 converter for a 904 non lockup. I recently finished the build on a 418 and need a converter before putting the car back together. If you have one that you could part with, used/new, whatever, please send me a PM and what you would like to get for it. Thanks
  7. MJD323

    No mine. Just thought I would share...

    Not Mine and I know nothing about it. I just saw it on craigslist and thought it may be of interest to someone. http://atlanta.craigslist.org/nat/pts/3068708061.html New Hemi for sale 500 dollars, needs valve according to the ad.
  8. MJD323

    My 418 Build

    Hey, I previously had this thread going in the Racers forum but decided to needed to be moved here as I plan to drive the car on the street WAY more than it will see any race track. I have ordered and received my kit from Race-Mart. The kit is the cast crank with the ICON forged pistons...
  9. MJD323

    416 Stroker Kit Question

    Hey, I recently started the rebuild on my 340 after spinning a rod bearing. I have been informed that that the block is already punched .040. When looking at stroker kits I see that most are only offered with pistons up to .030. I was able to find a kit through Muscle Motors that offers the kit...
  10. MJD323

    Power steering pump pulle question

    Hey Guys, I have a question about the proper installation of a pulley on a power steering pump. I am able to move my pulley in and out of the pump about 3/8 of an inch. I believe this to be the source of my 'slapping' noise while driving the car. I have tried removing the pump and pushing the...
Back
Top