Search results for query: *

i used 2" x 2" square tubing, cut the floorboards once tubing was welded to the sub frames I welded the floor boards to the tubing, it is super stiff. Intrusion into floor boards not a problem.

I used 4:10 gears and a 518 od tranny from a 92 Dakota. Comes outmof the hole like a rocket and turns 2000 rpm a 100km/per hour in OD

Don't ignor the crank trigger

Obd1 less complicated and works just fine

I used a 95 obd1 pcm on my 2001 found out the hardway you must match your injectors to the pcm. That is 95 pcm and 95 injectors!

I used a dodge van ps pump bracket, and a Dakota V6 altenator bracket. Serpentine works just fine.

I changed my kmember to a 74 in my 72. Used 74 motor mounts worked,fine. Also the 74 kmember allowed me to use 76 Cordoba disk brakes

I used a Dakota V6 alternator bracket

As I said the 8-1/4 is just fine. The rear end housing is out of an 80's Dippy with the diff out of an 80's van (in the van its called an 8-3/8). The reason for the dippy housing is it is 3" wider than the A body. I needed the extra width because I used 2003 Jeep liberty rims.

8-1/4 is holding up just fine

I installed a 2001 5.9l with a 92 518 od tranny in my 72. I run 4:10 gears in an 8-1/4 with sure grip Changed the computer and injectors to 95 and OBD1 Used a custom wiring interface from the Detail Zone. Runs Extremely well.

1972 Dodge Dart Swinger Resto-mod

When I disconnect the rear bake line from the proportioning valve and pump the brakes the is no flow what so ever. R

Yes I have done that. I do have front brakes working. Thanx for the reply R

Hi, I have a problem with no rear brakes on my 72 Swinger. Technical 74 front spindle Actually replaced the whole K Member 76 Cordba 11-3/4" front disks and calipers using a manual brake set up 2 bolt master cylinder from later model Mopar New disk brake proportioning valve 81 dippy rear...

Wanted Autoxray 10130 scanner Please PM me RSW

Sorry got tied up. Do you still have this trim? R

Btt

Has any body dealt with Dante's Mopar Parts? I am looking to purchase their vinyl roof. Thanx R

Do you still have these parts?

Do you still have these items?

Are these items still available?

You can use this email address dartrod@telus.net

Sent you a PM with my e-mail address R

I am looking for Vinyl roof trim for a 70-74 Dart Swinger.:headbang:

I am interested in seeing you pics of this trim

I am interest in seeing a pic of the Vinyl Roof trim you hive advertised. Ralph Walker

Great tip will try it this AM