Search results for query: *

I have to admit when i bought the car from Tom it had a pretty good 4 scale balance.

I wish I had a fiberglass trunklid. the springs are gone and it weighs a ton.

I understand your dissapointment with Riess. There is some hacky work and rushed work that I have been fixing for years. Reason I asked about the upper is someone hacked out half of my upper and butchered the fix. I cut it out and did a temp fix but now I want to replace with a beefier upper...

Hi what upper cross member did you use. Im planning To go TKX in my Valiant.

My 71.

Like a Gear Vender. Thought about it. worried about the short Driveshaft.

I plan to lower the stall almost half. This is motor and trans from my Drag only Dart. Ran low 10s Going into a Barracuda to Run a Drag an Drive event.

For typical 408 to 410 stroker race combos whos switched or tried going from there race gear setup to a street gear. 3.23, 3.55,3.73. What change did you make to convertor stall if any.

It was a good show they through the rule book out. My friend was able to run his convertible Dart into the high 12s and bracket race went 3 rounds.

I have seen 3 different posters with 3 different gate opening times on Friday. Just curious

Has anyone ever seen a crack through the weld on an 8 3/4 center section. looking at the rear of the round center at 12 Oclock going counter clockwise to 10 Oclock. Its cracked through the weld about 3 inchs. This is on a Narrowed 8 3/4 with ladder bars.

I just went through this this past weekend. im running 29.5 x 10.5 MT my first round It was 95 I did my usual smokey burnout my sixtys were way off that day.

Dusterdoug, where did you find that battery hold down.

Bluecuda what fuel do you run. I was planning on running one of my spare W2 motors.

Anyone here run in these. Im signed up for the Redwood Rally.

Has anyone here signed up to run this. This is a Drag and Drive event.

They already set there Dates. And Calander.

Where is this posted. Thanks

I was talking about the yearly Mopar Muscle Car shootout. late September. I was testing there today.

Does anyone Know if its on this year. Its not on the Callander usually late September.

Thanks

Did you run this with motor plate or stock mounts.

Hi, what size are the hose fittings. Thanks

No one I trust to try.

o1heavy Did yoy run the 50cc in the rear.

Thanks Demonx2 I will look into that.

I thought that at first as it did it out of the box. Plugs look good. It seems to bog when the secondaries crack open.

Pumps are adjusted fine tried 35 squirters no help. Primary side works fine when seperated from secondaries. Discharge in squirters is fine through the intire shot.

fuel pressure is good. I can rev it in nuetral and it bogs as soon as the secondaries start to open.

Just bought this carb as soon as i try to open secondaries it lean bogs. Played with jetting running a plug in the rear now throwing jets at it still bogs 408 W2s 12-1 650 solid roller. Indy 360 intake. It idles fine just wont transition . stock jetting 84-84 with 4.5 power valves Im at 88...