Search results for query: *

Ok, I’m sending it today Address is 855 hwy 1011 Napoleonville,La 70390

Ok let’s do it

What’s shipping to 70390

Ok thanks, don't know if it'll fit the 66 dart , I'll check on it

My bad, 66 slant six

will take them for $25 and free shipping

wanted ; complete power steering set up ( brackets, pump,steering box, steering shaft, etc) will take donor car if it’s a standard car and close enough to retrieve

looking for a hood for my 1966 dart gt, trim not needed but will take it all if available Thanks

what about a bad vacuum leak , clamp off your PCV hose

https://www.shope.com.ar/contenido/productos/1453835569.pdf to much to list, check this out for all the specs

$1800

thermal dynamics plasma cutter for sale or trade, new was $3600 , will take $2500 , like new , barely used

have you tried pulling one plug wire at a time while running and listening for a change, that may locate the problem if its one cylinder

after a rub down

thanks for all the input guys, i think i have it sold

double check firing order ?

I have a complete a/c and heater box out of a 66 dart, it has everything on it including the controls and dash piece, as you can see from the pictures the little tips on the back have rotted off but all the buttons are in great shape, the evap, heater core, fan motor and wire harness is there...

I have a thermal Dynamics Cut Master 102 Plasma Cutter I'm looking to sell. I've used it a few times in the several years I 've had it and it works fine but now I have no use for it. New they are around $3500 but I'm asking $2500 plus shipping

had it happen to me, turned out to be loose converter bolt

Thanks guys for all the great input

my 66 dart/225 auto doesn't have a choke thermostat and it seams to be a problem locating one. any ideas or maybe a part number

update, ordered a new pitman arm for the hell of it and when compared to the old one it was obvious that it was bent. looks like it was bent down to clear the oil pan for the v 8 and when turned all the way right it would bind up on the center link. every things fine now, nice and tight...

I've bin looking for pictures to see if my pitman arm is starting in the right spot maybe you only get 2 and 1/2 turns to the left no luck with yet maybe one of you guys can check yours. ?

Thanks guys but I'm out of town working for a few weeks I'll give an update when I get back

Yes I did have a four wheel alignment on it from a decent shop I got to watch him do it and everything was in spec. I'm going to order a new pitman arm cause mine just don't look right. ( what is the correct turning radius ? Anyone know where to go to find it ? ) my tierods are not even do I...

my 66 gt with s/6 and manual steering dosn,t have the same or even close turning radius from left to right , about 35ft to the leftwith 3 full turns and 49ft to the right with pretty close to 3 full turns, thats inside to inside. a little history, the car originally had power steering, yanked...

let me take some pictures this weekend and post them to make sure it,s what you want

neutral safety switch ?

i have two aluminum hood scoops, don.t know what they come off of exactly, they have some pitting and need to be polished

well couldn,t find factory ride hight specs so i put it where it looked ok, about an inch and a quarter lower and went back to the shop, took our time inspecting it for anything loose or cracked and re alligned it again, looks like its holding but i think there is a problem. has anyone had...