Search results for query: *

Has anyone ran into a loose jet on a carb out of the box?

Wat would b a good setting for my carb as far jets. I no Ppl have given me some choices on carbs but what would b a good one for this lil teen (my intake is an old Holley dominator).

timing is set at wat should b stock i believe 10btc

ok now im not sure how much vac is suppose to b in the ported with slight throttle movement. as to i dnt get much chance to work with older engines at my work i get mainly electronically controlled vehicles

it is a low stall converter in a 727 with i wana 2.76 ratio in the rear but this all happens in park havent been able to drive it since i need tires

when it stumbles i dnt smell fuel or see black smoke. but straight from the box would you say this carb is to rich for this engine? the carb number is 4776s

well i should say it stumbles badly but ill check that when i get a chance

i have the carb on the car and have started it the only issue i have is a hesitation on quick acceleration otherwise on slow it will rev fine

i have a stock 318 that had a 2bbl on it ran good with that wanted to switch to a 4bbl was told a 600cfm dp would work good on it would that carb b worth my time tuning it to my engine or should i put it on the shelf and get a different carb if so what would b a wise choice for it?

ya i dont hear no noises from it and its held up so far done a few hard take offs when the car had a 2bbl now has a 4bbl and just needs to b tuned and hopefully it holds up to it then

the pic is upside down

Ya I say it's the 7.25

ok what size would the stock rear end be cause i know its not the 8.75

i have a 72 duster was originaly a standard trans car has small rear end with small bolt pattern im curious as to what ratio the rear end has

It's an 84

I figured it out since my truck has a "spark computer" and originally one wire went from there to the neg side of coil and I guess my coil was to much for it so I took it off and it ran alot better

I drove it runs like crap. I adjusted the advance curve on it and it feels good when idling but as soon as I go down the road it's just sputtering non stop

Well I'm gona drive it tomorrow to c if it'll smooth out as the fresh gas gets up

That's exactly how I wired it as they show in the instructions of the dist. Since the truck sat for almost a yr I'm kinda thinking its the gas in the truck is bad but I'm not totally sure

Before I bought the dist and coil summit and msd told me that it doesn't plug into the stock harness cause my stock dist is a dual pick up coil. The msd wiring is on wire goes to coil positive other goes to coil neg another to engine ground and the last wire is a tach signal

Ok this is on my truck. I had the engine out so I can reseal it and put a new oil pump in. I put a new timing chain and gear set in with an msd dist and coil. I got it started and timed right I go to rev it up and sputters and dies down if I hold throttle still but if I play with the throttle...

ok so it might be easier for to buy a tool to figure it out. since the wheels i have on now the rear has a neg offset and the wheels im looking at getting have a positive offset

ok would you say its narrower or wider than the original

well it has the 7.25 rear end which is what i was meaning by small rear end but i do know that it is a 5 by 4.5 bolt pattern

does anyone know the wheel fitment on a stock 72 duster with the small rear end. im wanting to know the max backspacing, negative and positive offset, and biggest rim i can go (though im only goning to go with a 16") without any modifications at all. i know its a 5 by 4.5 bolt pattern. had a...

That's the thing is finding a quiet one for a mopar they are all ovr for ford and chevy

There's only 2 wires that go to the dist nd as for comp there's only one on the air cleaner and that I believe just measure air intake or something

What is like to have in there is a msd ignition my truck has no vac adv but yet it's an 84 and I like the way it runs just wish I could go to a 4bbl

Ya I think ill stick to a chain and get rid of my vac adv dist

to b honest idk if this engine has the original chain and gear set. the engine in car is not the original one the engine i was told from a '68 pickup