Search results for query: *

Thanks everyone for your input. Some good practical solutions which have inspired me to persist with my SD508 which I was using in the factory location (before installing the torqstorm and electric water pump). Cannot reinstall in that location because of the water pump pulley delete. I cut...

Nice one! Obviously one groove instead of two is better, thanks for that info. I've noticed an electric pump for $600 on eBay (which compares to around 400-500 depending on manufacturer for a SD7B10), so I'm deciding between the two options. Where are you planning to mount your compressor? Nice...

Thanks! I hadn't come across these before and you might be onto a winner. I've done some preliminary searching and it looks like there are two types, the "standard" and the "light". The below is all the info i could manage to find about the AC Delco range (?), and i'm trying to confirm with...

Hello everyone, Has anyone seen or heard of an AC compressor mounted down low on the drivers side of a small block (where the power steering pumps usually sit; rear of the compressor close to the engine mount bracket)? Relatedly, what's the smallest (shortest) AC compressor you've come across...

For anyone looking at this thread in future (and who can use them for manufacturing), I've attached the DXF's of my work. https://sharpe.be/valiant/2022/LA360%20Alternator%20Brace%20(Meziere%20Compatible).DXF...

Had to re-route the upper radiator hose using a 90 bend of 1.5" aluminium tubing as it interfered with the SC, drilled some extra 3mm holes into and then fit the tridon thermostat. Used a 120deg 10AN fitting at the spare 1"NPT water pump inlet to plumb heater. Filled with water, turned the pump...

got any pics? What are you doing with your thermostat? Did you try restrictor plates? Thanks

Thanks! What do you do with respect to the circuit used to activate the pump, and deactivating it (at shut down? timed with electric fan after shut down? any battery drainage issues if so?) Turned some steel spacers (2x 29mm, 2x 32mm, 1x 90mm). Water jet an arm to support the long alternator...

Thanks for the info and interest everyone. I emailed Meziere and was told that I can plumb the heater return into either (a) the second 1" NPT inlet port in the water pump (currently plugged), or (b) into my lower radiator hose (i.e. plumb them into low pressure points). Not sure which I'll do...

Hi everyone, Have begun the process of installing the Meziere WP114SHD electric water pump, WP115U backing plate, and Torqstorm ARP-K-DG-LA single supercharger kit on my LA360 stroker. Am working through the mount modifications I need to make (alternator on RHS, SC on LHS) and if anyone is...

for the time being i've decided to just fit the 10225 shift kit. 10225 instructions are found here: http://files.dpbrands.com/bm/instructions/10225.pdf if you are unfamiliar, the 10225 mods are as follows: remove a few check balls remove 1-2 accumulator piston return spring (interestingly, no...

Hi all, I've managed to lose a couple of the springs supplied in the B&M 10228 kit and I haven't been able to find replacements (only option seems to be to buy a whole kit - seems like a waste of $100 for three springs). I've still got a green and a red spring. My question: Is it risking...

Hi everyone, I'm locking my distributor and i'm trying to confirm if i need an MSD 6530 if i'm using the #30004, or if i can just use an MSD 5520 instead. FiTech help (email) hasn't been great so i'm trying here. Can anyone who has one of the FiTech units let me know: 1. after locking the...