Search results for query: *

I'm stalling pretty strong Steel Caps so I don´t think it would distort. More concerned about the stress this can cause on the engine block.

Hello folks, reading the ARP instructios it says 110lb/ft of preload for main studs and head studs. Is that correct? It seems too much...

Hello folks, I'm trying to adjust rear band as per instructions, 72 inch pound than back 3.5 turns. But looks like its over tightened and looking the rear drum. Have vou seen this ? Double wrap band. I have to turn it much looser to be able to turn rua drum by hand again. My best regards,

Hello transmission experts, I´m thinking in installing a dump valve system but I can't use transbrake VB in the class I run. Boosted application so need to increase my launch RPM to create some boost. My torque converter flash stall it´s 3500rpm but I just can footbrake to around 2000rpm. If I...

As I see in most of manufacturers: 8740 700hp, 2000 1100hp, L19 1400hp. This information changes from vendor to vendor but also some says 8740 just can rev up to 7000rpm and 2000/L19 to 8000rpm. But, I´m just trying to be cautious as I´ll run boost.

Hello guys, have any of you done a bolt upgrade on small block Scat H-Beam 8740 to Arp 2000 or L19? Remember any specs or part number? Thanks and BR,

Hello, Need a 904/727 cheap transbrake. Can be Cheetah, A&A, TCI, etc... please send me a PM.

Hello guys, I'm rebuilding a A904 tranny and need your opinion on this. Not possible to swap to a 727 as there aren't many around my area. The Car will be a 408ci/W2 boosted and the aim to reach at least 800hp. I've ready that some drive racers would prefer using A904 due to reduced internal...

Hello all, I would like to buy this KIT from PST but I need moog K704 upper ball joint for my Dart... I already asked them but they just give their specs. Are any of you aware if the upper ball joint its the same as K704? Thanks,