Search results for query: *

Check ballast resistor. Had same problem and ballast resistor was issue.

Asking for a friend who has a 67 barracuda. Problem is when he gets on it the front end rises up but stays up until you roll car or push down on front of car. Has tubular upper control arms but otherwise stock suspension. Upper arms were rubbing on mounts but are clearanced and free movement...

Update- Finally got around to getting 2nd opinion on x block. I sent block to Bill Richardson in Lynchburg VA. I had explained over phone to him about the dilemma with the block. He got block and inspected the main bore alignment and said no problem he can do it. The bores he sonic tested and...

Im sure 14" but you can contact him at 920-973-0196

Posting for friend. He is in Two Rivers WI.

SOLD

No info selling for a friend. Contact bill at 920-923-0196 text only please.

I understood your comments and was only curious about rumblefish's comment that he has seen/heard of more than a couple being only able to go to 4.04. That would mean a different pattern was used. And is contrary to info i have gotten which prompted me to post this thread. I am going to take...

Transmission cooler with filter. $25

Hubcaps $40

68 Barracuda tailight lenses. One is chipped. $100 obo.

67 Barracuda tailights complete. $250

Thank you guys for your inputs. I really appreciate it. So was there different patterns used for castings that made some thin bore and somethick bores?

Well thats what i always understood as being the case. I thought it would be very unlikely they would use a different pattern for casting x blocks. Not sure about sonic testing without boring, i have no knowledge in this area.

So they cast x blocks with different patterns?

Small bolt pattern spare tire in good condition. $25

Ok had my nos x block at machinist to have 4 bolt mains installed and line bored. Was told the line bore is way off and that bores were sonic checked and would only be good for a 4.04 bore. Never has been bored and is 3.91 rough factory bored. Which puzzled me and I'm finding this hard to...

Thanks ill check it out.

Looking for non tinted drivers door glass and left quarter glass for 70 dart 2 door.

Looking for good used factory roller cam for 1999 or 2000 5.9l magnum.

Well thanks everyone for your responses. I'll check into your suggestions. Hope Ryan is ok. He treated me well and seemed like a nice guy. His expertise will be missed greatly by all.

M My brothers project.

Thanks l talk to him..

Thanks for input..I would strike borchardt off that list but thanks.

Don't know what to tell you always answered mine before as well.

I liked work but hes not responding to emails about doing them and it took 2 yrs to do my w5 heads.

Who has had experience getting w2 iron heads ported and by who. Had my w5 heads done by Ryan at Shady Dell. Thanks.

Please let me know of quality machinists in wisconsin. Please have experience using them at least once. Thanks.

Do you still have or make bushings for clutch pedals?