Search results for query: *

As title mentions. Will need a picture to verify the part you have. David

Has anyone used the adapter for installing a 440 distributor on a low deck? It makes me wonder if there would be any problem with oil getting to the lower shaft bushing and causing a long-term durability issue. Has anyone noticed any ill-effects using this adapter set-up? David

Does anyone out there have a Holley electric choke setup that they removed from their 4150 Holley? I have a 3310 that I just rebuilt, and it is a manual-choke model. I would like to try it as an electric choke. Hope to hear back!

Has anyone done this? I have this torqflite with a stubby output shaft. It was a Craigslist find. The previous owner did not know where it originated from. How about you guys??? There is no bolt flange in the back, so it doesn't look like a drum parking brake-equipped motorhome...

Up for sale is a 7 1/4" axle out of my 1968 Dart. This rear worked well, and was pulled out of the car a couple of months ago. It was pulled because it was replaced by an 8 3/4" rear axle. The car got a big block swapped in and the Slant-6 was removed at the same time. This axle was never...

Looking for a reasonably-straight & unbroken instrument cluster for my '68 Dart. Please PM me with what you have. Big thanks!

I have a 1966 440 block that didn't pass inspection at my machine shop. The cracks are 1 on each side, near where cylinders are. My machinist says he could probably "pin" it, but since they are near cylinder barrels, they probably won't hold over the long term with a performance build, which is...

Up for sale is a 7 1/4" axle out of my 1968 Dart. This rear worked well, and was pulled out of the car last month. It was pulled because it was replaced by an 8 3/4" rear axle. The car got a big block swapped in and the Slant-6 was removed at the same time. This axle was never operated behind...

Up for sale is a 7 1/4" axle out of my 1968 Dart. This rear worked well, and was pulled out of the car last month. It was pulled because it was replaced by an 8 3/4" rear axle. The car got a big block swapped in and the Slant-6 was removed at the same time. This axle was never operated...

Hey gang I want to sanity-check my line of thinking on my 5.9 Magnum engine. I want to install this in my '65 Valiant Convertible, but I'm concerned about using the stock Magnum heads. I'm aware the stock heads have a propensity to crack between the intake & exhaust valve seats, but I have...

I need TWO small bolt pattern steel wheels. I believe they are the 5.5"-wide steelies. I'm in SoCal, and am willing to take a drive depending on where you are. Please see attached photos. I'm looking for the match to that wheel. Note: I may consider the 4.5"-wide wheels, but then I would...

Looking for a V8 center link for my 1965 Valiant. Car is currently a slant 6, but is getting a v8 transplant. I'm in 91350, SoCal. Hope to hear from someone! Thanks

Hey guys. Looking for a carb for my /6 project. Already have an Offy 4 bbl manifold, and just attached a newly-rebuilt head to my '68 Dart. Looking for an Edelbrock 500 cfm (preferably an AVS), or a Holley 8007 390 cfm. Hope to hear back.

Hello & nice to meet you all. My first post here, and it is primarily because of my new aquisition, which is a '68 Dart Sport Special notch coupe. It was a recent Craigslist find, and is a VERY COOL little father/son project that I'm taking on with my 16-yr old. It is currently stock and...