Search results for query: *

One more question are your wheels 4 inch bolt pattern or 4 1/2 bolt pattern/spacing? Thank you.

The back rally are 8"? If I may ask who's wheel brand? From which company did u buy? I'm interested in getting some. Thank you.

What in there now is more than enough! I run a Standard lx101 in my dart sport 360. Its a hot little motor! 292 mopar purple shaft, 3.91's out back 850 thermoquad on a Victor 340 intake. 340 X-heads etc.. it's a mean machine. Doesn't miss a beat!!!

The intake you have should be fine.

Non detergent is for lawnmowers! Just use the zinc fortified oils mentioned and you'll be fine.

My inbox?

Next in line if 69fbcuda doesn't take it.

I just recently installed same problem solver bushings. All I did was use a rubber mallet to open/spread outer tabs out. In went control arms. Still went in snug but their in!

Would this adjustment apply to a 1974-75 dodge dart sport too? My car sometimes only starts in nuetral. Or occasionally in park it's hit or miss.

Doesn't Racer Brown carry grinds very close to purple cams?

Yuck!

There's Bowers frame and alignment which I'm not sure of address but I now they do older vehicles too.

Run em!!

These rotors work on 1974 dodge dart 360?

Is the rear mini tabbed? Stance is killer! Have rear wheel backspace? 15x10's?

Exercise more. Been putting it off. Easier said than done though!:(

Won't hurt anything to leave casting flash. Numerous people just use as is no issues.

Doesn't Racer Brown carry mopar grinds similar to the mopar cams? Howard's also has some similar when I checked sometime ago.

I run the 292 purple hydraulic cam. It's been just fine! Never any issues. Not sure what year its made but also used to run a 280 purple cam before and also was very reliable! I've heard comp cams being junk!

Your dart have a 8 3/4 or 8 1/4? 8 1/4 is narrower.

What is CWC cast camshaft?

Sorry you already gave me an answer!

Inzane240 when you put together front suspension did you tighten everything with weight if car? Or when it was on lift? Did you torque nuts on suspension? I ask since I'm getting ready to assemble my dart sports front end. Just seeking pointers/advise thanks.

In my 360 tried rn12yc motor still pinged. Had timing set @ 18° initial and total 34 or 35. Cam is mopar 292 purple grind. 108° lobe separation. Advanced cam 6° @ the crank with kb107 pistons. Iron x heads. So had to change to rn9yc champion's. Now no ping and have vacuum advance hooked!

If not bought I'm interested.

Synthetic not needed. Conventional with zinc be happy!

Did u keep stock lower rubber bushings in lower control arms? Also did you tighten everything with the weight of car or up on lift? I ask cuz I'm getting ready to put my dart sport front end together. Thank you!

This works on tuff wheel too?

I am using all stock rubber replacement bushings.