Search results for query: *

do you know what the actual number is on the lunati cam I'm in central michigan

A close friend of mine bought a 1969 nova 396 375 hp square alm heads close ratio 4 speed brand new. It would rev like crazy to over 8000, raced a brand new 340 gts auto, the dart jumped him every time out of the hole and he beat the nova every time they raced. He even put a set of 488 gears in...

Mine is a res med also was told could not get tubing or face mask. I found tubing on ebay mine says motor has expired but still works.One of the things that this thing does is it still will run at a real low volume when shut off so the motor runs all the time unless you unplug it.

Do you have pay pal address send to me pm I will see what we can do

I wish we were closer and not layed up they look good because the bumps are not close to the combustion chamber I can’t travel or drive for a least a couple of weeks are the rockers needle bearings

how high above regular surface is the big bump on second head

the first head looks pretty good the second almost looks like a weld is it or not

Thank you

I am very interested in the heads and rockers.I just got out of the hospital after a complete hip replacement looks like I will be layed up for awhile. Where are the dings located on the heads could you please send pictures me.

pm me on details for payment i am in mi

have you still got the valves

how tight of bearing clearance and who's bearings are you builders using

4.15 stroke 6.76 forged rods

this is a 496 cu in low deck

getting rotating back this week full balance went to this cu in son bought the wiseco pistons for me had trouble finding 400 block that was not too worn to go to the bore had one but needed the bigger bore found one out of estate car going in 69 dart my oldest son bought about 20 years ago had...

pm me on heads shipping to mi do you take pay pl

are these are right out of the box when you bought them no work done stock rpm springs I'am interested in them

I'm still interested just a little concerned it might be ecm how old is it and did you update the software pm me maybe we can work something out.

was your 440 a mild build, so all I will need is a o2 bung the wiring looks pretty straight forward do you take pay pal

do you have to use the timing to make it work right if so what dizzy do they use interested in it for my build.

have these been clearanced for pushrods

How do you what payment

Bb how do you m

Do

do you still have rods have you checked them or not

whats your bottom dollar if we pick them up this week

these take reg length valve we are building a 499 dart with the 4.15 crank we got from you and wiseco 10 1/2 pistons do you think these would do a good job for a street strip car

what machineing needs to be done and what size valve stem size