Search results for query: *

Pro Form 66488 is a tool that installs the bushing and burnishes it as the tool comes out. I am not a fan of some of Pro Form stuff, but this tool works great. It is a good idea to check gear pattern with a marking compound like used for setting up diff. gears to see if contact pattern is in the...

I need 2, they are 3/8" fine threads 2 3/4 " long left hand threads. These bolts hold the sure grip carrier together on the 489 diff. case using the clutch type sure grip. Thanks

No, my customer brought it to me with the broken bolts and had already removed them.

I am in need of 2- 3/8" X 2 3/4" fine thread left hand thread bolts for the 8 3/4" clutch type sure grip unit. Any body out there have any extras or blowed up unit that they will sell me 2 bolts?

HELP please, I crashed my comp eliminator 93 Daytona and need to find a full right rear quarter panel and right tail light assembly to make repairs. thanks

The easiest way to remove them and also pipe plugs is to thermal shock them. to do this you heat the nipple or pipe plug being removed with a torch. do not heat the cast housing. The nipple or pipe plug does not have to be red hot but needs to be hotter than a propane torch will get it, so it...

As an engine builder I would say your right on track. Used factory cranks are subject to condition and sizing. If they are undersized it is possible to have been damaged and have a hair line crack that is not noticeable. If it is std. size it may be worn and need to be turned to get back to a...

I am interested in the non AC, dual sheave ps, crank pulley set for small block.

They are still available from mopar. If not I have new ones in Stock.

Bent pushrods can also happen with coil bind and valve spring breakage can be from coil bind. Instead of pointing fingers at what is already a bad situation, concentrate on the cure. Do a leak down test on all cylinders. Make sure you have at least .060" valve spring clearance. from spring...

Hi, I am interested in 1 of the 4972s 71 340 4-speed carbs. How much and what condition? thanks Randy

you can buy them direct from your mopar dealer and it is not a p- part. I buy them by the dozen and keep then in stock for my customer engines. part number 2899530

This is a trick I use to avoid align honing blocks when installing studs. I use a drill press and drill all the main caps out to the next larger size. Make sure to deburr the cap mating surface and give that a try. It normally works because the stud diameter is larger than the bolt diameters and...

I am looking for a pair of w8 valve covers. Mopar performance made them in magnesium or aluminum. manufactured sheet metal covers also. What do you have?

Hi guys, long time drag racer, started with 71 duster, currently racing 93 Daytona always small blocks. I am an engine builder and have 2 sons with 71 dusters each.