Search results for query: *

Installing QA1 Strut rods on my 70 Dart and ran into an issue with the locking nut on the control arm side. Due to the size of the nut, the angle the rod is at and the opening size in the lower control arm I'm unable to shorten the length of the strut rod enough. The locking nut hits up against...

Putting an S&W 8 Point roll bar in the Dart with the straight rear bars and trying to determine where they land. I was hoping it would go through the package shelf, so I could keep the rear seats, but the bars are about two feet short. From the looks of things it could either mount on the frame...

Had to pull my trans apart after losing an o-ring on the rear clutch. Replaced the o-rings on both clutch packs, set the clearances for the plates and air tested them. The rear clutch engaged fine with about 30 psi of air, however the front clutch didn't really move. There is hardly any air...

Hi all, Looking for speedo gears for small block 727 in 36 and 42 teeth. Thanks! Tom

Trying to determine if the engine/transmission centerline angle of a small block would be the same with a 904 and 727. Going to be a while until I get the new engine/transmission in and wondering if I can setup the pinion angle for the rear axle using the current small block and 904? Thanks!

Hi all, Looking for a dome light/door switch for a 1970 Dart. I would prefer a drivers side one, but a passenger one would be fine. Thanks. Tom