Search results for query: *

thanks for correcting me ... i had a 69 Dart so my brain was throwing A body at me.

Has anyone put a modern day hemi/ gen 3 hemi in a 62 dart without hacking out the stock engine bay. i assume the trans tunnel may need some cuts for an automatic overdrive transmission. I'm interested in doing an old school meets modern project. Old body / modern guts.

Anyone going East to West Soon... 70 Coronet Transport Needed. Or any Recommendations? Let me know. Thx Jeff

Hi All, checking to see if anyone is doing any transport from AZ(85262) to CA (94062) or any buddies /People to recommend. Purchasing a Dodge Coronet -Jeff

ok on it. thank you for the advice

idle about 700 no idea about torque converter to be truthfully honest... when i bought car the transmission was still in the car with the torque converter and No motor.. so I just went forward and proceed to drop the motor and fire.

If your sitting in Park and you just put in Reverse the car will reverse at like 10 mph with no gas given on ide. It’s like it’s very low geared.

UPDATE!!! GOOD NEWS AND BAD NEWS ]The Good! 1.Fixed the shift shaft lever leak! 2.Fixed the oil pan leak.. love those Summit cast pans with the drain plug! The Bad! 3.The car still pulls hard in reverse with no gas given.... help any ideas why? (bad valve body)??? 4.It now goes into Park after...

was just looking at that

thank you

ok pm sent

Yes true but to much back space rubs the spring

any particular pan and gasket a favorite of yours?

Hi All, Need all the help i can get! have 2 young boys makes it difficult to spend countless hours taking this apart and mindless trouble shooting. Opting for solutions and advice from the A Body Mopar Fam I am about to change oil pan gasket for the 3rd time.........BUT seeing as that wont be...

can you send a quick picture to my cell

cool im interested

looking for 15x8 wheel with backspace 4.5 or less and small bolt pattern or uni lug pattern to fit original A Body rear end pic for attention and similar set up (not my car)

i just need the dipstick. Anyone have an extra laying around? thx

i dont think that would be the right one

yes correct, this ^

Hi All, Looking for a Bench Seat for 67 Barracuda Notchback. Thanks

Hi Guys, Newly Built 318 with performer intake and stock heads, stock cam and other stock parts, pistons etc in a 67 cuda with a 904 trans. Timing is set and runs great on idle. When put into ANY gear car will bog down and stall. Give it gas and it will stay running. Never have had this happen...

lovely but she looks too old for me

i thought so, thank you

i did some research i might be able to move it in the right spot. will play with it and let you know.

I'm gonna try that but from the looks of it I've got no where to rotate too

Hi All, i dropped my engine in with a right angle adapter and its never gonna work. it runs right into the exhaust. I need to go back to original plate and nipple that goes right up to the block. Can someone tell me where i can get the plate & nipple and any other needed gaskets? I see Summit...

Found, thank you all!

Thanks so much i am ready to drop in my engine, so let me know.

Hi I am looking for a small block flex plate located anywhere in SF Bay Area. Let me know if you have one.